Processor; Setup Menu Settings; Setup Menu Organization; System Setup - Sony DFS-700 Service Manual
Dme switcher, digital/analog input board, analog composite input board, digital multi effects board, 3d video mapping effects board
Hide thumbs
Also See for DFS-700:
- Operating instructions manual (212 pages) ,
- Specifications (8 pages)
Table of Contents
Advertisement
Connections for an A/B Roll Editing System
When using the BVE-2000
Control the M/E and downstream keyer through the 9-pin connector. You
can control M/E and downstream keys simultaneously.
Player VCR A
DFS-700/700P control panel
REF
VIDEO
IN
AUDIO
LINE
VIDEO OUT
REMOTE
OUT
1
DFS-700/700P
processor
VIDEO
INPUT
VIDEO
INPUT
1
VIDEO OUT
REMOTE
REF
3
3
VIDEO
VTR
IN
VTR
AUDIO
LINE
Player VCR B
OUT
REF IN
2
LINE IN
2
LINE IN
Video and audio signals
SRP-V200R Audio Mixer
Control signals
Black burst signal (reference
synchronizing signal)
Cables used
1 These depend on the type of VCR being connected. Check with the instructions
supplied with the VCR.
2 XLR (3-way) cables
3 RCC/5G/10G/30G 9-pin remote control cables
4 RCC11A audio mixer control cable
A/B roll editing system connections (2) — using the BVE-2000
6-6
Chapter 6 System Connections and Settings
VIDEO
REF
OUT
VIDEO
IN
Recorder VCR
VIDEO
REMOTE
AUDIO
IN
IN
BLACK
1
BURST
OUT
PGM OUT
3
3
EDITOR
VIDEO SW' ER
VTR
BVE-2000 Editing Control Unit
4
EDITOR
SRP-L300 Delay Unit
LINE OUT
Setup Menu Settings
Setup Menu Organization
The setup menu is divided into eight pages, and each appears as shown in
the following example.
Example display:
Menu name
SYS
SCREEN
PRE RD
A "P" appears here when
P 1/8
4:3
OFF
preread editing is on.
Values
Page
System Setup (page 1/8)
Button
Setting
Meaning
F1
SCREEN
Set screen aspect ratio.
F2
PRE RD
Toggle preread editing on/off.
When this is on, a "P" appears at the
beginning of line two of the menu
display.
F3
PORTS
Select type of editor connected to
EDITOR connector.
(See table below.)
F4
TALLY
Toggle rear panel tally output signal on/
off.
CpnIN
F5
Assignment of
(Only appears when
numbers to rear panel
optional BKDF-702/702P
COMPONENT
is installed.)
connectors
5
/
to
8
/
1
4
F3(PORTS) setting and control
Values
Valid control for each connector
EDITOR connector
PVE-500 DVS control
BVE-600 –
GPI
–
PORTS
TALLY
CpnIN
Settings
To submenu
PVE500
OFF
IN 4
Values
(First value is factory default.)
4:3/16:9
OFF/ON
PVE-500/BVE-600/GPI
(Select "PVE500" when a BVE-2000 is
connected.)
OFF/ON
IN1-4 r: assign 1
1-4/5-8
to 4.
To confirm displayed assignment, press
F3(OK); to cancel press F5(CANCEL).
IN5-8 r: assign 5
to 8.
GPI/T 1
GPI/T 2
–
DSK transitions
Auto transitions
Auto transitions
DSK transitions
6-7
Chapter 6 System Connections and Settings
- Quick Links:
- Manual Structure
Hide quick links:
Advertisement
Table of Contents
