hit counter script

Characters Are Distorted Or Incorrect; System Cooling Fans Do Not Rotate Properly; Diskette Drive Activity Light Does Not Light - IBM @server xSeries 343 Product Manual

Ibm @server xseries 343 server product guide
Table of Contents

Advertisement

Characters Are Distorted Or Incorrect

Check the following:
Are the brightness and contrast controls properly adjusted on the video monitor? See the
manufacturer's documentation.
Are the video monitor signal and power cables properly installed?
If the problem persists, the video monitor may be faulty or it may be the incorrect type. Contact
your service representative or authorized dealer for help.

System Cooling Fans Do Not Rotate Properly

If the system cooling fans are not operating properly, system components could be damaged.
Check the following:
Is AC power available at the wall outlet?
Is the system power cord properly connected to the system and the wall outlet?
Did you press the power button?
Is the power on light lit?
Have any of the fan motors stopped (use the server management subsystem to check the fan status)?
Are the fan power connectors properly connected to the server board?
Is the cable from the front panel board connected to the server board?
Are the power supply cables properly connected to the server board?
Are there any shorted wires caused by pinched cables or power connector plugs forced into power
connector sockets the wrong way?
If the switches and connections are correct and AC power is available at the wall outlet, contact
your service representative or authorized dealer for help.

Diskette Drive Activity Light Does Not Light

Check the following:
Are the diskette drive power and signal cables properly installed?
Are all relevant switches and jumpers on the diskette drive set correctly?
Is the diskette drive properly configured?
Is the diskette drive activity light always on? If so, the signal cable may be plugged in incorrectly.
If you are using the onboard diskette controller, use the BIOS Setup Utility to make sure that
"Onboard Floppy" is set to "Enabled." If you are using an add-in diskette controller, make sure that
"Onboard Floppy" is set to "Disabled."
If the problem persists, there may be a problem with the diskette drive, server board, or drive signal
cable. Contact your service representative or authorized dealer for help.
xSeries 343 Product Guide
65

Advertisement

Table of Contents
loading

Table of Contents