Table of Contents
Advertisement
8 Upgrading the Hardware
Tools and Supplies Needed
Procedures in this section require the following tools and supplies:
•
Jumper-removal tool or needle-nosed pliers
•
Small flat-bladed screwdriver
•
Phillips* (cross-head) screwdriver (#2)
•
Heat Sink Clip Attach/Removal Tool - may be ordered/purchased from:
•
Anti-static wrist strap and conductive foam pad (recommended)
NOTE
Blue-colored items (such as handles, buttons, and screws) represent service
touch points. Remove power from system before servicing these components.
Green-colored items (such as handles, levers, and buttons) represent hot-
pluggable components.
Equipment log: As you integrate new parts into the system, add information about them to your
equipment log (see Appendix A). Record the model and serial number of the system, all installed
options, and any other pertinent information specific to the system.
Cautions
These warnings and cautions apply throughout this chapter. Only a technically qualified person
should configure the server hardware.
CAUTIONS
System power on/off: The power button DOES NOT switch off system
power. To remove power from the system, you must unplug/disconnect the
power connections. Make sure power connections are unplugged/disconnected
before you open the chassis, add, or remove any components.
78
Dexter Design (United States)
(503) 648-7000
Contact: dxtrdsgn@aol.com
P/N: 650308-003-P6
Figure 13. Tools and Supplies Needed
TP205
Upgrading the Hardware
Advertisement
Table of Contents
