Dot1X - Cisco Catalyst Blade Switch 3130 Reference Manual
For dell command reference
Hide thumbs
Also See for Catalyst Blade Switch 3130:
- Software configuration manual (1354 pages) ,
- Hardware installation manual (84 pages) ,
- Manual (42 pages)
Table of Contents
Advertisement
dot1x
dot1x
Use the dot1x global configuration command on the switch stack or on a standalone switch to globally
enable IEEE 802.1x authentication. Use the no form of this command to return to the default setting.
Though visible in the command-line help strings, the credentials name keywords are not supported.
Note
Syntax Description
system-auth-control
Defaults
IEEE 802.1x authentication is disabled.
Command Modes
Global configuration
Command History
Release
12.2(40)EX1
Usage Guidelines
You must enable authentication, authorization, and accounting (AAA) and specify the authentication
method list before globally enabling IEEE 802.1x authentication. A method list describes the sequence
and authentication methods to be used to authenticate a user.
Before globally enabling IEEE 802.1x authentication on a switch, remove the EtherChannel
configuration from the interfaces on which IEEE 802.1x authentication and EtherChannel are
configured.
If you are using a device running the Cisco Access Control Server (ACS) application for IEEE 802.1x
authentication with EAP-Transparent LAN Services (TLS) and with EAP-MD5, make sure that the
device is running ACS Version 3.2.1 or later.
Examples
This example shows how to globally enable IEEE 802.1x authentication on a switch:
Switch(config)# dot1x system-auth-control
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
2-90
dot1x system-auth-control
no dot1x system-auth-control
Enable IEEE 802.1x authentication globally on the switch.
Modification
This command was introduced.
Chapter 2
Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
OL-13271-01
Advertisement
Table of Contents
