Table of Contents
Advertisement
Installing or Replacing a Fabric Module
Caution
Keep your face away from the front of the fabric module so that the levers do not hit your face when they
spring out from the front of the module.
Figure 28: Unlocking a Fabric Module from its Slot
1
Press the eject button.
2
Handles spring out from the module.
b) Grasp each of the two levers with your two hands and fully rotate the levers out 90 degrees from the fabric module.
c) Pull both levers until the fabric module is about 3 inches (7 cm) out of the chassis (see Callout 3 in the previous
figure).
d) Rotate both levers back to the front of the module.
Each lever clicks when it locks in place at the front of the module.
e) Grasp the front of the module with one hand, place the other hand under the module to support its weight, and pull
the module out of the slot (see Callout 2 in the previous figure).
Be careful not to touch any electrical contacts on the back of the module. Handle only covered sides or
Caution
edges of the module.
f) Place the module on an antistatic surface or inside an antistatic bag.
Step 3
Install the new fabric module in the chassis as follows:
a) Unpack the new fabric module and inspect it for damage.
If anything is damaged or missing, contact your customer representative immediately.
b) Hold the front of the module with one hand and place the other hand under the module.
c) Rotate the module clockwise and align the back of the module to the module guides at the top and bottom of the open
fabric slot in the chassis.
Cisco Nexus 7706 Hardware Installation Guide
86
Installing or Replacing Modules, Fan Trays, and Power Supplies
3
Pull the handles to partially remove the module
from the slot.
OL-31330-01
Hide quick links:
Advertisement
Table of Contents
