Table of Contents
Advertisement
Hardware settings
Do the following procedure as you install fax boards.
To set switch block SW1
The switch block SW1 settings determine the fax ports' I/O
addresses.
The CP4/LSI Series 1 board contains four fax ports. Depending
on the configuration of the Unity server and on whether Active-
Fax is installed on a separate server, you can install up to eight
CP4/LSI Series 1 boards.
Set the SW1 switches on each board as shown below.
First board
Ports 0–3
Second board
Ports 4–7
Third board
Ports 8–11
LED status indicators
There are two LED status indicators for each fax port. The fol-
lowing table describes the meaning of the status indicators.
Color
Lit
Green
Port is off hook
Amber
Board is
operational
APPPENDIX A: Voice and fax boards
SW1
switch
On
Fourth board
Off
1 2 3
Ports 12–15
On
Fifth board
Off
1 2 3
Ports 16–19
On
Sixth board
Off
1 2 3
Ports 20–23
Unlit
Port is on hook
Board is not
operational
SW1
switch
On
Off
1 2 3
On
Off
1 2 3
On
Off
1 2 3
Blinking
---
Board configuration
problem
139
Advertisement
Table of Contents
