Table of Contents
Advertisement
8. System control
Refer to the outdoor unit installation manual.
. Installing the grille
Fig. 9-1
Fig. 9-2
Fig. 9-3
Fig. 9-4
4-directional
1 pattern: initial setting
Blowout
direction
patterns
2-directional
6 patterns:
2 air outlet fully closed
Blowout
direction
patterns
Table 1
Fig. 9-5
.1. Checking the contents (Fig. -1)
• This kit contains this manual and the following parts.
?
.. Preparing to attach the grille (Fig. -)
• With the gauge 3 supplied with this kit, adjust and check the positioning of the
• Make sure that the opening in the ceiling is within the following tolerances:
• Make sure that A is performed within 17-22 mm. Damage could result by failing
..1. Removing the intake grille (Fig. -3)
• Slide the levers in the direction indicated by the arrows 1 to open the intake
• Unlatch the hook that secures the grille.
• With the intake grille in the "open" position, remove the hinge of the intake grille
9.2.2. Removing the corner panel (Fig. 9-4)
• Remove the screw from the corner of the corner panel. Slide the corner panel as
.3. Selection of the air outlets
3-directional
For this grille the discharge direction is available in 11 patterns. Also, by setting the
4 patterns:
remote controller to the appropriate settings, you can adjust the air-flow and speed.
one air outlet fully closed
Select the required settings from the Table 1 according to the location in which you
want to install the unit.
1) Decide on the discharge direction pattern.
2) Be sure to set the remote contoller to the appropriate settings according to the
Note:
For 3 and -directional, please use the air outlet shutter plate (option).
9.4. Installing the grille
9.4.1. Preparations (Fig. 9-5)
• Install the 2 enclosed screws with washer 2 in the main unit (at the corner drain
Main unit
Screw with
captive washer
Accessory name
1
Grille
2
Screw with captive washer
3
Gauge
4
Fastener
5
Screw
6
Screw
7
Wireless remote controller
8
Wired remote controller
9
i-see sensor corner panel
unit relative to the ceiling. If the unit is not properly positioned relative to the ceil-
ing, it may allow air leaks or cause condensation to collect.
860 × 860 - 910 × 910
to adhere to this range.
A Main unit
B Ceiling
C Gauge 3 (inserted into the unit)
D Ceiling opening dimensions
grille.
* Do not unlatch the hook for the intake grille.
from the grille as indicated by the arrows 2.
indicated by the arrow 1 to remove the corner panel.
[Fig.9-3] [Fig.9-4]
A Intake grille
B Grille
C Intake grille levers
D Grille hook
E Hole for the grille's hook
F Corner panel
G Screw
H Detail
number of air outlets and the height of the ceiling on which the unit will be in-
stalled.
pipe area and at the opposite corner) as shown in the diagram.
Q'ty
Remarks
1
950 × 950 (mm)
4
M5 × 0.8 × 25
1
(Divided into 4 parts)
3
4
4 × 8
1
4 × 12
1
for PLP-6BALM, PLP-6BALME
1
for PLP-6BAMD,PLP-6BAMDE
for PLP-6BAE, PLP-6BAMDE,
1
PLP-6BALME
1
Hide quick links:
Advertisement
Table of Contents
