Device
Description
parameters
Set measurement
Temperature correction for specified /
start
simulated sensor LRL value to
desired LRL temperature value
Temperature correction for specified /
Set measurement
simul. Sensor measurement value at
end
desired URL temperature value
Trim 4 mA
Output signal correction for specified
/ simul. Sensor LRL at 4,000 mA
setpoint
Output signal correction for specified
Trim 20 mA
/ simul. Sensor URL at 20,000 mA
setpoint
Output signal simulation
Simulation
corresponding to the value specified
Pos: 19.16 /==== Leeres Modul mit einer Absatzmarke, IM, 1-spaltig ==== @ 14\mod_1194422545687_0.doc @ 136717
Pos: 19.17 /Konfiguration, Parametrierung/Temperatur/TTR200/Werkseinstellungen @ 16\mod_1196672946593_3101.doc @ 143933
7.7.1
Factory settings
The transmitter is configured in the factory. The following table contains the values for the individual parameters.
Menu
Description
DeviceConfig
Write Protect
Input
Process Alarm
HART Tag
HART Descriptor
Pos: 19.18 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
OI/TTR200-EN
Communication and configuration
DTM parameters
<Device> <Maintenance> <Adjust>
<Device> <Maintenance> <Adjust>
<Device> <Maintenance >
<Adjust /DAC compensation fixed for
zero point at 4 mA>
<Device>
<Maintenance >
<Adjust /DAC compensation fixed for
amplification at 20 mA>
<Device> <Simulation>
Parameters
-
Sensortype
R-Connection
Measured Range Beginn
Measured Range End
Unit
Damping
Failure-signal
-
-
TTR200
Effective range
Trim low or
Set Lower Range Value> ok
Trim high or
Set Upper Range Value> ok
Analog current measurement value input
min. 3,5 ... max. 4,5 mA
Analog current measurement value input
min. 19,5 ... max. 20,5 mA
3,5 ... 23,6 mA
Factory setting
No
Pt100 (IEC751)
3-wire
0
100
Degrees C
off
Override 22 mA
-
TIXXX-
29