Connecting A Voice Isdn Bri Line - Cisco 800 Series Hardware Installation Manual
800 series integrated services router
Hide thumbs
Also See for 800 Series:
- Design manual (50 pages) ,
- Release notes (36 pages) ,
- Configuring (32 pages)
Table of Contents
Advertisement
Cisco 860, 880, 890 Series
This option allows a stepped offhook resistance during seizure, which avoids overloading the circuit
during offhook in the event that ringing voltage is present on the circuit at the same time as the trunk
seizure. The stepped offhook resistance is initially set to 800 Ohms, then adjusts to 50 Ohms when
ringing voltage is not present.
To enable the soft-offhook command on the port, and to access the connection command with plar opx
syntax, see the
Connecting a Voice ISDN BRI Line
Use a straight-through RJ-45 cable to connect the voice BRI port to the ISDN network through a
telephone outlet or other device.
To prevent damage to the router, be sure to connect the BRI cable to the BRI connector only and not to
Caution
any other RJ-45 connector.
To connect the voice BRI line, follow these steps:
Step 1
Connect one end of a straight-through RJ-45–to–RJ-45 cable to the Voice BRI port.
Note
Cisco Integrated Services Router Hardware Installation Guide
3-42
Cisco Command Lookup
When the interface is configured as NT and is connecting to a TE device, use a crossover cable.
See
Table
A-27.
Tool.
Chapter 3
Connecting the Router
- Quick Links:
- Hardware Features
Hide quick links:
Advertisement
Chapters
Table of Contents
