Cisco 7906G Administration Manual page 154
Unified ip phone for cisco unified callmanager 4.1(3)
Hide thumbs
Also See for 7906G:
- Administration manual (278 pages) ,
- User manual (112 pages) ,
- User giude (90 pages)
Table of Contents
Advertisement
Chapter 7
Status Menu
Table 7-4
Status Messages on the Cisco Unified IP Phones 7906G and 7911G
Message
BootP server used
Error Verifying
Config Info
CFG TFTP Size Error The configuration file is too
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager
7-10
Viewing Security Information, Model Information, Status, and Statistics on the Cisco Unified IP Phone
Description
The phone obtained its IP
address from a BootP server
rather than a DHCP server.
The name-based and default
configuration file was not
found on the TFTP Server.
large for file system on the
phone.
Possible Explanation and Action
None. This message is informational only.
The configuration file for a phone is created
when the phone is added to the
Cisco Unified CallManager database. If the
phone has not been added to the
Cisco Unified CallManager database, the
TFTP server generates a
response.
Phone is not registered with
•
Cisco Unified CallManager.
You must manually add the phone to
Cisco Unified CallManager if you are not
allowing phones to auto-register. See the
"Adding Phones with Cisco Unified
CallManager Administration" section on
page 2-14
for details.
If you are using DHCP, verify that the
•
DHCP server is pointing to the correct
TFTP server.
•
If you are using static IP addresses, check
configuration of the TFTP server. See the
"Network Configuration Menu" section
on page 4-7
for details on assigning a
TFTP server.
Power cycle the phone.
CFG File Not Found
OL-10008-01
Advertisement
Table of Contents
Troubleshooting
