hit counter script

Configuring Traffic Engineering Tunnel Bandwidth; Confirming Diffserv-Te Bandwidth - Cisco CRS Configuration Manual

Ios xr mpls configuration guide
Hide thumbs Also See for CRS:
Table of Contents

Advertisement

Implementing RSVP for MPLS-TE and MPLS O-UNI

Configuring Traffic Engineering Tunnel Bandwidth

To configure traffic engineering tunnel bandwidth, you must first set up TE tunnels and configure the reserved
bandwidth per interface (there is no need to configure bandwidth for the data channel or the control channel).
Cisco IOS XR software supports two MPLS DS-TE modes: Prestandard and IETF.
For prestandard DS-TE you do not need to configure bandwidth for the data channel or the control channel.
Note
There is no other specific RSVP configuration required for this application. When no RSVP bandwidth
is specified for a particular interface, you can specify zero bandwidth in the LSP setup if it is configured
under RSVP interface configuration mode or MPLS-TE configuration mode.
Related Topics
Configuring a Prestandard DS-TE Tunnel, on page 231
Configuring an IETF DS-TE Tunnel Using RDM, on page 233
Configuring an IETF DS-TE Tunnel Using MAM, on page 235

Confirming DiffServ-TE Bandwidth

Perform this task to confirm DiffServ-TE bandwidth.
In RSVP global and subpools, reservable bandwidths are configured per interface to accommodate TE tunnels
on the node. Available bandwidth from all configured bandwidth pools is advertised using IGP. RSVP signals
the TE tunnel with appropriate bandwidth pool requirements.
SUMMARY STEPS
1. configure
2. rsvp
3. interface type interface-path-id
4. bandwidth total-bandwidth max-flow sub-pool sub-pool-bw
5. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Purpose
Enters global configuration mode.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring Traffic Engineering Tunnel Bandwidth
123

Advertisement

Table of Contents
loading

Table of Contents