Gas Pressure Regulator - Miele KM 342 Installation Instructions Manual
Hide thumbs
Also See for KM 342:
- Technical manual (50 pages) ,
- Operating instructions manual (24 pages) ,
- Installation instructions manual (20 pages)
Table of Contents
Advertisement
Gas connection
Gas pressure regulator
A pressure regulator that is convertible
from natural to LP gas is included with
the appliance. The included regulator
corresponds with the gas type of the
cooktop. Verify before installing.
The adjusted pressure is:
natural gas - 4" w.c.
LP gas - 10" w.c.
a Cooktop
b ½" NPT
c Regulator
As shown in the above diagram, the
included regulator must be used when
connecting the Miele cooktop to your
gas supply. This item has been
customized by Miele to meet all
applicable safety requirements. Make
sure the regulator is easily accessible
for adjustment after the appliance has
been installed.
14
For convenience, an AGA or CGA
approved flexible stainless steel gas
hose (accordion type) may be used
between the gas connection and the
regulator. This will allow the appliance
to be lifted out of the countertop for
cleaning or servicing. Make sure that
any drawers, cabinet doors, etc., do not
rub on this gas hose.
Do not use any regulator unless it
has been supplied by Miele. Doing
so may cause a gas leak.
If there is any doubt concerning
installation contact the Miele Technical
Service Department at:
U 1-800-999-1360
techserv@mieleusa.com
V 1-800-565-6435
service@miele.ca
After connecting the appliance check
all fittings for gas leaks e.g. with
soapy water.
When installed properly, the flame will
be steady and quiet. It will also have a
sharp, blue inner core that will vary in
length proportional to the burner size.
Flame adjustment will not be necessary.
Advertisement
Table of Contents
