Default Vtp Configuration - Cisco Catalyst 2950 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Configuring VTP
VTP pruning is not designed to function in VTP transparent mode. If one or more switches in the
network are in VTP transparent mode, you should do one of these:
•
•
To configure VTP pruning on an interface, use the switchport trunk pruning vlan interface
configuration command (see the
pruning operates when an interface is trunking. You can set VLAN pruning-eligibility, whether or not
VTP pruning is enabled for the VTP domain, whether or not any given VLAN exists, and whether or not
the interface is currently trunking.
Configuring VTP
This section includes guidelines and procedures for configuring VTP. These sections are included:
•
•
•
•
•
•
•
•
•
Default VTP Configuration
Table 14-2
Table 14-2 Default VTP Configuration
Feature
VTP domain name
VTP mode
VTP version 2 enable state
VTP password
VTP pruning
Catalyst 2950 Desktop Switch Software Configuration Guide
14-6
Turn off VTP pruning in the entire network.
Turn off VTP pruning by making all VLANs on the trunk of the switch upstream to the VTP
transparent switch pruning ineligible.
Default VTP Configuration, page 14-6
VTP Configuration Options, page 14-7
VTP Configuration Guidelines, page 14-8
Configuring a VTP Server, page 14-9
Configuring a VTP Client, page 14-11
Disabling VTP (VTP Transparent Mode), page 14-12
Enabling VTP Version 2, page 14-13
Enabling VTP Pruning, page 14-14
Adding a VTP Client Switch to a VTP Domain, page 14-15
shows the default VTP configuration.
"Changing the Pruning-Eligible List" section on page
Default Setting
Null.
Server.
Version 2 is disabled.
None.
Disabled.
Chapter 14
Configuring VTP
13-24). VTP
78-11380-04
Advertisement
Table of Contents
Troubleshooting
