Enabling Or Disabling Microflow Policing; Enabling Microflow Policing Of Bridged Traffic - Cisco 6500 Series Software Configuration Manual
Hide thumbs
Also See for 6500 Series:
- Configuration manual (392 pages) ,
- Configuration note (212 pages) ,
- Installation manual (194 pages)
Table of Contents
Advertisement
Configuring PFC QoS
This example shows how to verify the configuration:
Router# show policy-map interface fastethernet 5/36
FastEthernet5/36
service-policy input: pmap1
class cmap1
class cmap2
Router#
Enabling or Disabling Microflow Policing
To enable or disable microflow policing (see the
Command
Step 1
Router(config)# mls qos flow-policing
Router(config)# no mls qos flow-policing
Step 2
Router(config)# end
Step 3
Router# show mls qos
This example shows how to disable microflow policing:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# no mls qos flow-policing
Router(config)# end
Router#
This example shows how to verify the configuration:
Router# show mls qos | include Microflow
Microflow QoS is disabled globally
Router#
Enabling Microflow Policing of Bridged Traffic
To apply microflow policing to multicast traffic, you must enter the mls qos bridged command on the
Note
Layer 3 multicast ingress interfaces.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
31-50
class-map: cmap1 (match-all)
0 packets, 0 bytes
5 minute rate 0 bps
match: ip precedence 5
police 8000 8000 conform-action transmit exceed-action drop
class-map: cmap2 (match-any)
0 packets, 0 bytes
5 minute rate 0 bps
match: ip precedence 2
0 packets, 0 bytes
5 minute rate 0 bps
police 8000 10000 conform-action transmit exceed-action drop
"Policers" section on page
Purpose
Enables microflow policing.
Disables microflow policing.
Exits configuration mode.
Verifies the configuration.
End with CNTL/Z.
Chapter 31
Configuring PFC QoS
31-19), perform this task:
78-14099-04
Advertisement
Table of Contents
Troubleshooting
