hit counter script

HP omnibook xt6200 Reference Manual page 142

Hide thumbs Also See for omnibook xt6200:
Table of Contents

Advertisement

Reference Information
Modem Reference Information
Command
Function (Ambit)
I12
Report driver time stamp
L0
Set low speaker volume
L1
Set low speaker volume
L2
Set medium speaker volume
L3
Set high speaker volume
M0
Turn speaker off
M1
Turn speaker on during handshaking and turn speaker off while receiving carrier
M2
Turn speaker on during handshaking and while receiving carrier
M3
Turn speaker off during dialing and receiving carrier and turn speaker on during answering
N0
Turn off automode detection
N1
Turn on automode detection
O0
Go on-line
O1
Go on-line and initiate a long retrain sequence
O2
Go on-line and initiate a short retrain sequence
P
Force pulse dialing
Q0
Allow result codes to DTE
Q1
Inhibit result codes to DTE
Sn
Select S-Register n as default
Sn?
Return the value of S-Register n
Sn=v
Set default S-Register n to value v
T
Force DTMF dialing
V0
Report short form result codes
V1
Report long form result codes
W0
Report DTE speed only
W1
Report line speed, EC protocol and DTE speed
W2
Report DCE speed only
X0
Report basic call progress result codes, i.e., Ok, Connect, Ring, No Carrier (also, for busy, if enabled, and
dial tone not detected), No Answer and Error
X1
Report basic call progress result codes and connections speeds (Ok, Connect, Ring, No Carrier (also, for
busy, if enabled, and dial tone not detected), No Answer, Connect XXXX, and Error
X2
Report basic call progress result codes and connections speeds, i.e., Ok, Connect, Ring, No Carrier (also,
for busy, if enabled, and dial tone not detected), No Answer, Connect XXXX, and Error
X3
Report basic call progress result codes and connections rate, i.e., Ok, Connect, Ring, No Carrier, No
Answer, Connect XXXX, Busy, and Error
X4
Report all call progress result codes and connections rate, i.e., Ok, Connect, Ring, No Carrier, No Answer,
Connect XXXX, Busy, No Dial Tone and Error
Y0
Report OK
Y1
Report OK
Z0
Restore stored profile 0 after warm reset
Z1
Soft reset and restore stored profile 1 after warm reset
&C0
Soft reset and force RLSD active regardless of the carrier state
&C1
Allow RLSD to follow the carrier state
&D0
Modem ignores DTR
&D1
Modem enters command mode at DTR drop
&D2
Modem hangs up at DTR drop
&F0
Restore factory configuration 0
&F1
Restore factory configuration 1
&J0
Set S-Register response only for compatibility
&K0
Disable DTE/DCE flow control
142
Reference Guide

Advertisement

Table of Contents
loading

Table of Contents