Numeric Error Codes - Lenovo ThinkPad L430 Hardware Maintenance Manual
Lenovo thinkpad l430; thinkpad l530 notebook
Hide thumbs
Also See for ThinkPad L430:
- User manual (198 pages) ,
- (194 pages) ,
- Benutzerhandbuch (194 pages)
Table of Contents
Advertisement
The symptom-to-FRU index in this section lists symptoms and errors and their possible causes. The most
likely cause is listed first, in boldface type.
Note: Do the FRU replacement or other actions in the sequence shown in the column headed "FRU or
action, in sequence." If replacing a FRU does not solve the problem, put the original part back in the
computer. Do not replace a nondefective FRU.
This index can also help you determine, during regular servicing, what FRUs are likely to need to be
replaced next.
A numeric error is displayed for each error detected in POST or system operation. In the displays, n can
be any number.
If no numeric code is displayed, check the narrative descriptions of symptoms. If the symptom is not
described there, go to "Intermittent problems" on page 43.
Note: For a device not supported by diagnostic codes in the ThinkPad notebook computers, see the
manual for that device.
Numeric error codes
Table 2. Numeric error codes
Symptom or error (beeps, if any)
0187
EAIA data access error—The access to EEPROM is failed.
0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190
Critical low-battery error
0191
System Security—Invalid Remote Change requested.
0251
System CMOS checksum bad— Default configuration
used.
0271
Real Time Clock error—check Date and Time settings.
1802
Unauthorized network card is plugged in—Turn off and
remove the Mini PCI network card.
2110
Read error on HDD0 (Main HDD)
2112
Read error on HDD2 (Mini SATA)
40
Hardware Maintenance Manual
FRU or action, in sequence
System board.
System board.
1. Charge the battery pack.
2. Battery pack.
1. Run ThinkPad Setup, and then save current
setting by pressing F10.
2. System board.
1. Charge the backup battery for more than 8 hours
by connecting the ac power adapter.
2. Replace the backup battery and run ThinkPad Setup
to reset the time and date.
Run ThinkPad Setup to reset the time and date.
1. Remove Mini PCI network card.
2. System board.
Main HDD
Mini SATA
Advertisement
Table of Contents
