Removing The Operator Information Panel Assembly - IBM 8849 Service Manual
Xseries 306m
Hide thumbs
Also See for 8849:
- User manual (74 pages) ,
- Problem determination and service manual (144 pages)
Table of Contents
Advertisement
2. Attach the drive-retention clip to the side of the drive.
3. Slide the drive into the CD/DVD drive bay until the drive clicks into place.
4. Replace the cover (see "Installing the cover" on page 73).
5. Slide the server into the rack.
6. Connect the cables and power cords (see "Completing the installation" in the
7. Turn on all attached devices and the server.
Removing the operator information panel assembly
To remove the operator information panel assembly, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the server from the rack and remove the cover (see "Removing the
4. Disconnect both cables from the operator information panel board.
5. Remove the screws that secure the operator information panel assembly to the
6. Lift the operator information panel assembly out of the server.
Installation Guide or User's Guide for cabling instructions).
on page 69.
all external cables necessary to replace the device.
cover" on page 72).
CD/DVD bay housing.
Chapter 4. Removing and replacing server components
87
Advertisement
Table of Contents
