Configuration Examples For Cisco Mpls-Te - Cisco ASR 9000 Series Configuration Manual
Aggregation services router mpls
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Implementing MPLS Traffic Engineering
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
mpls ldp
Example:
RP/0/RSP0/CPU0:router(config-ldp)# mpls ldp
Step 3
traffic-eng auto-tunnel mesh
Example:
RP/0/RSP0/CPU0:router(config-ldp-te-auto-mesh)#
traffic-eng auto-tunnel mesh
Step 4
groupidall
Example:
RP/0/RSP0/CPU0:router(config-ldp-te-auto-mesh)#
group all
Step 5
Use the commit or end command.
Related Topics
Auto-Tunnel Mesh, on page 153
Destination List (Prefix-List), on page 154
Configuration Examples for Cisco MPLS-TE
These configuration examples are used for MPLS-TE:
OL-28381-02
Purpose
Enters global configuration mode.
Enters MPLS LDP configuration mode.
Enters auto-tunnel mesh configuration mode. You can configure
TE auto-tunnel mesh groups from this mode.
Configures an auto-tunnel mesh group of interfaces in LDP.
You can enable LDP on all TE meshgroup interfaces or you
can specify the TE mesh group ID on which the LDP is enabled.
The range of group ID is from 0 to 4294967295.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuration Examples for Cisco MPLS-TE
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
251
Advertisement
Table of Contents
