Operating Instructions Dishwasher G 2143 en - US, CA To prevent accidents and appliance damage read these instructions before installation or use. M.-Nr. 07 724 060...
WARNING – When using your dishwasher, follow basic precautions, including the following: Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Use the dishwasher only for its intended purpose. This appliance is intended for residential use only.
Page 5
Do not install or use a damaged dishwasher. A damaged appliance is dangerous. Unplug the machine and call your Miele dealer or the Miele Technical Service Department. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of children.
Page 6
It will destroy the rinse aid compartment and water softener. If the power cord is damaged it must only be replaced by a Miele Service technician with a genuine Miele power cord. Disposal of an appliance...
Cutlery tray Upper basket Middle spray arm Air inlet for drying (depending on model) Lower spray arm Guide to the dishwasher Triple filter system Data plate Child Safety Lock in the door handle (not visible) Rinse aid reservoir Dual compartment detergent...
Guide to the dishwasher Control panel Program selection Time display Program sequence display On/Off button K Check/Refill indicators Start / Stop button with indicator Delay start button Turbo button with indicator Program button...
For best results follow these tips: ^ For lowest energy consumption you may connect the dishwasher to a cold water source. ^ For fastest possible wash times, with slightly higher energy consumption, connect the dishwasher to a hot water source.
To open the door ^ Press the release catch inside the door grip. If the door is opened during operation, the dishwasher will stop running. Once the door is closed the program will restart. To close the door ^ Push the baskets in.
Water softener Every dishwasher is tested before leaving the factory. Any water remaining in the machine is from the final factory test and does not indicate that the machine has been used. To achieve good cleaning results, the dishwasher needs soft water. Hard water results in calcium deposits on dishware and in the dishwasher.
To exit the programming mode at any time, turn the dishwasher off with the "K" button. ^ Turn the dishwasher off with "K". ^ Press and hold the program and "Start / Stop" button simultaneously turn the dishwasher on with "K". Hold the "Start / Stop"...
^ Clean any excess salt from the threads of the container opening. Screw the lid on firmly. ^ If the dishwasher will not be used immediately, run the "Express" program. This will remove any traces of salt from inside the wash cabinet.
Before using for the first time Rinse aid Rinse aid helps to prevent spotting on dishes and glassware. The rinse aid is filled in the reservoir and the set amount will be automatically dosed. Filling the rinse aid reservoir with detergent will damage the reservoir.
^ Turn the dishwasher off "s". ^ Press and hold the "Start / Stop" button and at the same time turn the dishwasher on "s". Hold the "Start / Stop" button until the "Start / Stop" indicator comes on. If it does not come on, start over.
Wax, grease and paint will cause permanent discoloration and damage to the dishwasher. ^ Scrape food from dishes before placing them in the dishwasher, rinsing is not necessary. ^ Some foods contain natural dyes, e.g. carrots or tomatoes. Plastic items may discolor permanently if they come in contact with food dyes.
The China & Crystal program, although extremely gentle and thorough can cause the china and crystal to "wear" if they are not dishwasher safe. Loading the dishwasher Glassware: – There are no standard guidelines for washing glassware, when in doubt wash by hand.
Loading the dishwasher Cutlery tray ^ Arrange the cutlery as shown in the cutlery tray. For easier unloading cutlery should be grouped in zones, one for knives, one for forks, one for spoons, etc. Place knives with the cutting edge down and forks with the prongs between the holders.
Upper basket Always use the dishwasher with the upper and lower basket inserted. ^ Load the upper basket with small, lightweight, or delicate items such as cups, saucers, glasses, dessert bowls and flat pans. ^ Long items such as soup ladles,...
Loading the dishwasher Adjusting the upper basket The upper basket can be raised or lowered to accommodate tall items. The basket can also be angled to fit tall items in both, the upper and lower baskets. The angles should not be set to opposite extremes.
Small plates and saucers can also be arranged in the lower basket. Loading the dishwasher Foldable spikes The foldable spikes can be used for small plates and saucers. Two rows of spikes can be folded down, to create more room for larger dishware, e.g.
Page 22
Loading the dishwasher Removable spike insert The spike insert can be removed in order to make room for larger tableware or to use a different insert. Removing the insert ^ To remove the insert, gently pull the handle upwards. Replacing the insert ^ Slide the hitches of the insert under the struts of the lower basket.
Page 23
^ Slide the hitches of the insert under the struts of the lower basket. ^ Push down on the handle to snap the insert into position. Loading the dishwasher Vase / Bottle insert (depending on model) The vase / bottle insert can be used to rinse narrow items, e.g.
Basket accessories Additional inserts for the upper and lower baskets may be purchased from your Miele dealer or Miele. Depending on the model some accessories come standard with the machine. Glassware insert GGO Multi-function basket GMFO Cappuccinatore insert GCEO Tall glassware insert GGU...
You can use powder, gel or tab detergents. Follow the dosage information on the detergent packaging. Detergent tabs are not recommended for use with the program "Express". The tabs may not dissolve completely. Dishwasher cleaning products are available from MIele.
Adding detergent ^ To open, press the latch on the detergent dispenser. The flap will spring open. The flap is always open at the end of a program. ^ Use one tab or add powder or gel detergent to compartment II and close the flap.
^ Open the water supply, if closed. ^ Open the door. ^ Make sure the spray arms can rotate freely. ^ Turn the dishwasher on "K". The "Start / Stop" indicator flashes and the indicator next to the last program selected is lit.
Program guide Program When to use For normally soiled pots Pots & and pans with dried on Pans food, also for heavily soiled dishware, use 120% of normal detergent amount For normally soiled Normal dishware For temperature sensitive China & glassware and lightly soiled Crystal dishware, use 50 % of...
To be completely safe, you must turn off the water supply to each individual appliance. This means under the sink for a dishwasher, at the laundry bib for your washer, etc.
Open the door with care. The water in the dishwasher is hot. Danger of scalding. Before closing the door again, leave it ajar for approx. 20 secs. This will enable the temperature in the wash cabinet to settle.
– If the "Rinse" indicator is not lit up: At least one setting has been altered from the factory defaults ^ To reset the dishwasher to the factory default settings, press the "Start / Stop" button. The setting is saved.
Gel detergent should not be used when selecting "Delay Start", the detergent could leak out of the compartment. ^ Turn the dishwasher on "K". The "Start / Stop" indicator flashes. ^ Select the desired program with the "Program" button. ^ Press the "Delay Start" button.
– Turn the dishwasher on "s". – Select the desired program with the "Program" button. – Press the "Start / Stop" button. If the problem persists, contact Technical Service. – Turn off the water supply. – Contact Miele Technical Service.
There may be water in the wash cabinet. Solution Open the water supply all the way. Before fixing the fault: – Turn the dishwasher off "s". – Open the water supply all the way. – Clean the water intake filter, see "User Maintenance Instructions".
General problems with the dishwasher Issue The display turns off. Detergent is left in the dispenser at the end of a program. The detergent lid cannot be closed properly. The door and the interior walls are still wet after a program has finished.
This may be caused by the installation or the diameter of the pipe. Solution Interrupt the program, rearrange items blocking the spray arms. Interrupt the program and rearrange loose pieces. This has no effect on the dishwasher. If in doubt contact a plumber.
Frequently asked questions Solution See "Loading the dishwasher". Select a more intensive program, see "Program Guide". Use more detergent, see "Adding detergent". Turn the spray arm and rearrange the dishes if necessary.
Page 38
Frequently asked questions Issue Dishes are still wet, glasses and cutlery are spotted. White residue is visible on cutlery and dishes. Clouding occurs on glassware and film can be wiped off. Possible fault The rinse aid setting may be too low, or the rinse aid reservoir is empty.
Page 39
– adjust the rinse aid dosage, – change the type and/or adjust the amount of detergent used, – connect the dishwasher to a cold water supply. There is no remedy. Only wash dishwasher safe glasses in the dishwasher. Select the ""SaniWash"...
Miele’s Service department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. Our goal is to prevent unauthorized (and untrained) service personnel from working on your Miele products, possibly doing further damage to them, you and/or your home.
To transport the dishwasher, e.g. when moving to a new home, note the following: – Empty the dishwasher. – Secure any loose parts, e.g. hoses, cables, cutlery baskets. – Transport the dishwasher in the upright position. If unavoidable it may be transported on its back. Do not transport it on its side or on the door.
The wash cabinet can be cleaned with a dishwasher cleaner such as "Dis Cleaner" available from your Miele dealer or online at www.miele.com. Door and the door seal ^ Wipe the door seals regularly with a damp cloth to remove food deposits.
The level of soiling and time it takes before the filters need cleaning will vary depending on your household usage. ^ Turn off the dishwasher before cleaning. Cleaning and Care ^ Turn the handle counterclockwise to release the triple filter system...
Page 48
Cleaning and Care To clean the inside of the filter, the flap must be opened. ^ Push the clips together the flap ^ Rinse under running water. ^ Close the flap so that the clip engages. ^ Return the filter so it lies flat in the base of the wash cabinet.
Sometimes particles of food get stuck in the spray arm jets. The spray arms should be inspected and cleaned every 4 - 6 months. ^ Turn off the dishwasher before cleaning. Removing the spray arms ^ Remove the cutlery tray (if present).
If your water contains a large number of insoluble substances, a filter between the water valve and the intake hose connection is recommended. These filters can be purchased from Miele. Cleaning the filter ^ Turn off the dishwasher and pull the plug.
If the dishwasher is not completely drained at the end of a program, the drain pump or non-return valve may be blocked. ^ Turn off the dishwasher and pull the plug. ^ Remove the triple filter (see "Triple filter system").
Installation Instructions Please refer to the Installation Diagram supplied with these instructions. To comply with IEC sound testing protocols, please contact Miele for additional instructions. Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information.
Danger of overheating! See data plate on the right side of the door. A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician. GROUNDING INSTRUCTIONS THIS APPLIANCE MUST BE GROUNDED.
Waterproof system All Miele dishwashers have a safety valve located on the incoming water line and a sealed underside with a water sensor. If a fault occurs, the water intake is stopped and the drain pump is activated. Connection to the water...
5 ft (1.5 m) flexible drain hose with an internal diameter of 7/8" (22 mm). – Drain hose extensions and adapters can be ordered from Miele. The maximum drain hose length is 13 ft. (4 m), max. drain height: 39"...
Page 60
Alteration rights reserved / 1911 M.-Nr. 07 724 060 / 02 G 2143 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.