Table of Contents
Advertisement
About this guide
Audience
This user guide is intended for system integrators and experienced users with at
least basic knowledge of configuring a workstation.
Contents
This guide contains the following parts:
1.
Chapter 1: Product Introduction
This chapter describes the general features of the workstation, including
sections on front panel and rear panel specifications.
2.
Chapter 2: Hardware setup
This chapter lists the hardware setup procedures that you have to perform
when installing or removing system components.
3.
Chapter 3: Motherboard information
This chapter gives information about the motherboard that comes with the
workstation. This chapter includes the motherboard layout, jumper settings,
and connector locations.
4.
Chapter 4: BIOS information
This chapter tells how to change system settings through the BIOS Setup
menus and describes the BIOS parameters.
5.
Chapter 5: RAID configuration
This chapter provides information on how to configure your hard disk drives
as RAID sets.
6.
Chapter 6: Driver installation
This chapter provides information on how to install the drivers for system
components. This chapter also describes the software applications that the
barebone workstation supports.
7.
Appendix: Reference information
This section provides information about the CPU features and technologies
and a troubleshooting guide for solving common problems when using the
barebone workstation.
x
Advertisement
Table of Contents
