Table of Contents
Advertisement
Available languages
Available languages
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A D
SYMPTOM
Skipping fasteners; intermittent
feed
Fasteners jam in tool
COIL NAILERS
Skipping fasteners; intermittent
feed
Fasteners jam in tool/canister
TROUBLESHOOTING GUIDE
WARNING: To reduce the risk of serious personal injury, remove
fasteners from magazine before making any adjustments or servicing this tool.
CAUSE
Leaking head cap gasket
Trigger valve O-ring cut/worn
Broken/chipped driver
Dry/dirty magazine
Driver channel worn
Wrong size fasteners
Bent fasteners
Loose canister/nose screws
Broken/chipped driver
Feed piston dry
Feed piston O-rings cracked/worn
Check pawl binding
Canister bottom not set correctly
Broken weld wires in nail coil
Wrong size fasteners for tool
Broken welded wires in nail coil
Wrong slide plate adjustment for
wire/plastic collated nail coil
WALT SERVICE CENTER OR CALL 1-(800)-4-D
e
FIX
Tighten screws/replace gasket
Replace O-ring
Replace driver (check piston O-ring)
Clean magazine
Replace nose/check door
Use only recommended fasteners
Discontinue using these fasteners
Tighten all screws
Replace driver
Add
D
WALT pneumatic tool oil
e
cover
Replace O-rings/check bumper and spring.
Lubricate assembly
Inspect pawl and spring on door. Must work freely
Set canister bottom for length of nails being used
Remove coil of nails and use another coil
Use only recommended fasteners/check canister
bottom adjustment
Remove coil of nails and use another coil
Adjust switch pins for wire/plastic collated
nail coil
14
WALT.
e
in hole in feed piston
Advertisement
Table of Contents
