After Use - NEC VT490 User Manual
Portable
Hide thumbs
Also See for VT490:
- Installation manual (7 pages) ,
- Quick setup manual (2 pages) ,
- User manual (79 pages)
Table of Contents
Advertisement
After Use
Preparation: Make sure that the projector is turned off.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt feet if extended.
4. Cover the lens with the lens cap.
5. Put the projector and accessories in the supplied soft case.
Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from
damage.
NOTE: When placing the projector in the soft case, retract the tilt feet and the rear feet. Failure to do so may case damage to the
projector.
CAUTION:
Use caution when putting the projector in the soft case immediately after the projector has been operating. The
projector cabinet is hot.
Insert the projector with the lens
facing upward
3. Projecting an Image (Basic Operation)
29
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
