hit counter script
Sony SA-TS22W Service Manual
  1. Manuals
  2. Brands
  3. Sony Manuals
  4. Speaker System
  5. SA-TS22W
  6. Service manual

Sony SA-TS22W Service Manual

Surround speaker system
Hide thumbs
Table of Contents

Advertisement

Quick Links

SERVICE MANUAL
Ver 1.1 2004.08
• SA-TS22W is speaker system in
DAV-FR10W/SR4W.
Sony Corporation
9-879-098-02
Audio Group
2004H16-1
Published by Sony Engineering Corporation
© 2004.08
SA-TS22W
SPECIFICATIONS
Surround (L)
Speaker system
Two-way Bass reflex
Speaker unit
70 mm dia. cone type,
25 mm dia. balance-dome-
type tweeter
Rated impedance
4 ohms
255 × 1112 × 255 mm
Dimensions (approx.)
(w/h/d)
Mass (approx.)
5.0 kg
General
Surround speaker (L)
Power requirements
220-240 V AC, 50/60 Hz
120 V AC, 60 Hz
P
ower consumption
36 W (220-240 V AC)
Design and specifications are subject to change
without notice.
SURROUND SPEAKER SYSTEM
US Model
Canadian Model
AEP Model
UK Model
E Model
Australian Model

Advertisement

Table of Contents
loading

Related Manuals for Sony SA-TS22W

Summary of Contents for Sony SA-TS22W

  • Page 1 SERVICE MANUAL US Model Canadian Model Ver 1.1 2004.08 AEP Model UK Model E Model Australian Model • SA-TS22W is speaker system in DAV-FR10W/SR4W. SPECIFICATIONS Surround (L) Speaker system Two-way Bass reflex Speaker unit 70 mm dia. cone type, 25 mm dia. balance-dome-...

  • Page 2: Table Of Contents

    PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REMPLACER CES COM- POSANTS Fig. A. Using an AC voltmeter to check AC leakage. QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.

  • Page 3: General

    SA-TS22W Ver 1.1 SERVICING NOTE Label After service, as shown in a figure, a power cord is fixed. power cord SECTION 1 GENERAL This section is extracted from instruction manual. Surround speaker (L) The surround speaker (L) incorporates the IR receiver. It receives the sound from the IR transmitter and sends it to the surround speaker (R).

  • Page 4: Diagrams

    SA-TS22W SECTION 2 DIAGRAMS • Note for Printed Wiring Boards and Schematic Diagrams Note on Printed Wiring Boards: Note on Schematic Diagrams: • All capacitors are in µF unless otherwise noted. (p: pF) • X : parts extracted from the component side.

  • Page 5: Printed Wiring Board - Diat Amp Board (Side A)

    SA-TS22W 2-1. PRINTED WIRING BOARD — DIAT AMP BOARD (SIDE A) — :Uses unleaded solder. POWER LED DIAT POWER DIAT POWER BOARD BOARD BOARD CNP400 CN905 CN904 DIAT AMP BOARD (SIDE A) (Page 12) (CHASSIS) (Page 10) (Page 10) C161...

  • Page 6: Printed Wiring Board - Diat Amp Board (Side B)

    SA-TS22W 2-2. PRINTED WIRING BOARD — DIAT AMP BOARD (SIDE B) — :Uses unleaded solder. DIAT AMP BOARD (SIDE B) Q111 R199 C234 X102 Q107 IC113 R217 R129 C143 R123 R259 Q112 C253 Q102 R198 R152 C222 C221 R146 R262...

  • Page 7: Schematic Diagram - Diat Amp Board (1/3)

    SA-TS22W • Refer to page 16 for IC Pin Function Description. • See page 14 for IC Block Diagrams. • See page 4 for Waveforms. 2-3. SCHEMATIC DIAGRAM — DIAT AMP BOARD (1/3) — (1/3) Q301 Q303 R310 R301 2SC2712G-TE85L...

  • Page 8: Schematic Diagram - Diat Amp Board (2/3)

    SA-TS22W • See page 14 for IC Block Diagrams. 2-4. SCHEMATIC DIAGRAM — DIAT AMP BOARD (2/3) — (2/3) C256 C257 C258 C259 0.01 0.01 0.01 0.01 CN104 SPEAKER R153 R156 R157 R159 100k R154 100k 100k R158 100k 100k...

  • Page 9: Schematic Diagram - Diat Amp Board (3/3)

    SA-TS22W • See page 14 for IC Block Diagrams. • See page 4 for Waveforms. 2-5. SCHEMATIC DIAGRAM — DIAT AMP BOARD (3/3) — (Page 8) (3/3) L110 10µH L111 L116 10µH 10µH C179 C202 C196 C187 C220 L122 1µH...

  • Page 10: Printed Wiring Board - Diat Power Board

    SA-TS22W 2-6. PRINTED WIRING BOARD — DIAT POWER BOARD — :Uses unleaded solder. EXCEPT MX, TW (Page 5) S901 IC901 IC905 POWER IC903 CONNECT IC904 (Page 5) BOARD CN904 (Page 12) • Semiconductor Location Ref. No. Location Ref. No. Location...

  • Page 11: Schematic Diagram - Diat Power Board

    SA-TS22W 2-7. SCHEMATIC DIAGRAM — DIAT POWER BOARD — R917 R922 C915 F901 CN903 C904 C905 D911 PC902 PC123Y22J00F C902 FH901 FH902 0.22 10EDB60TA1B2 1/4W 1/4W R902 C901 LF902 R919 TP911 0.22 14MH 0.7A D901 1.5k 1/2W D3SB60F3 TH901 TP912...

  • Page 12: Printed Wiring Board - Diat Built Pd Section

    SA-TS22W 2-8. PRINTED WIRING BOARD — DIAT BUILT PD SECTION — :Uses unleaded solder. IC7302 (Page 5) IC7301 (Page 5) DIAT POWER (Page 5) BOARD CN903 (Page 10) • Semiconductor Location Ref. No. Location D400 B-12 D7301 (Page 5) D7302...

  • Page 13: Schematic Diagram - Diat Built Pd Section

    SA-TS22W 2-9. SCHEMATIC DIAGRAM — DIAT BUILT PD SECTION — C7320 0.01 L7302 C7308 IC7301 CXA3668N-T4 6.3V R7302 C7312 R7301 0.0047 2.2k R7304 C7304 0.0068 L7303 L7306 R7303 D7304 1.5k PP508 C7303 C7311 L7301 C7313 C7314 CN7301 0.01 L7304 C7324...
  • Page 14 SA-TS22W • IC Block Diagrams – DIAT AMP Board – IC101 XC62HR1502MR IC110, 112 CXD9774M VOUT GVDD B GVDD GVDD B CURRENT BST B LIMIT DVDD DREG DREG GND 1 – PVDD B GATE PWM BP 2 PVDD B RECEIVER...
  • Page 15 SA-TS22W – DIAT POWER Board – IC901 STR-W6765N DRIVE REGULATOR REGULATOR PROTECTION START/STOP & ICONST – LATCH BURST DELAY BURST CONTROL NC 2 S/GND 3 VCC 4 SS/OLP 5 – SOFT START FB 6 – – – BOTTOM SELECTOR COUNTER –...
  • Page 16 SA-TS22W • IC Pin Function Description • DIAT AMP BOARD IC107 MB89537APFM-G-565-BNDE1 (SURROUND AMP CONTROLLER) Pin No. Pin Name Description Not used MOD2 Setting terminal for the CPU operation mode Fixed at “L” in this set 3, 4 Not used...
  • Page 17 SA-TS22W Pin No. Pin Name Description — Power supply terminal (+3.3V) MAIN_OFF Power off control signal output to the power control “H”: power off V_CONT Voltage control PWM signal output to the shunt regulator DAMP_LATCH Latch control signal output to the stream processor...

  • Page 18: Exploded Views

    SA-TS22W SECTION 3 EXPLODED VIEWS NOTE: • -XX and -X mean standardized parts, so they • Abbreviation The components identified by mark 0 or may have some difference from the original : Australian model dotted line with mark 0 are critical for safety.

  • Page 19: Cabinet, Front Panel Section

    SA-TS22W 3-2. CABINET, FRONT PANEL SECTION supplied supplied supplied supplied S901 supplied supplied supplied supplied F901 supplied supplied supplied supplied supplied Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 2-048-751-01 SCREW +BVTP 3.5X14 TYPE2 0 64...

  • Page 20: Electrical Parts List

    SA-TS22W SECTION 4 DIAT AMP ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • COILS When indicating parts by reference number, uH: µH parts list may be different from the parts please include the board name. specified in the diagrams or the components •...
  • Page 21 SA-TS22W DIAT AMP Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark C189 1-162-966-11 CERAMIC CHIP 0.0022uF 10% C259 1-162-964-11 CERAMIC CHIP 0.001uF C190 1-125-898-91 CERAMIC CHIP 0.22uF C300 1-216-864-11 SHORT CHIP C191 1-125-898-91 CERAMIC CHIP 0.22uF...

  • Page 22: Q104

    SA-TS22W DIAT AMP Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark IC107 6-804-310-01 IC MB89537APFM-G-565-BNDE-1 R111 1-216-813-11 METAL CHIP 1/10W IC108 8-759-583-47 IC uPC2933T-E2 R112 1-216-809-11 METAL CHIP 1/10W IC109 8-759-491-47 IC TC74VHCT08AFT (EL) R113 1-216-809-11 METAL CHIP...
  • Page 23 SA-TS22W DIAT AMP DIAT BUILT PD Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R174 1-216-864-11 SHORT CHIP R262 1-216-809-11 METAL CHIP 1/10W R175 1-216-818-11 METAL CHIP 1/10W R263 1-216-829-11 METAL CHIP 4.7K 1/10W R301 1-216-841-11 METAL CHIP...
  • Page 24 SA-TS22W DIAT BUILT PD DIAT POWER Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark D7302 8-719-058-49 DIODE PP508 C907 1-165-886-11 CERAMIC CHIP 3300PF 630V D7303 8-719-058-49 DIODE PP508 (AEP, UK, EA, HK, SP, KR, AUS, CH, E41)
  • Page 25 SA-TS22W DIAT POWER Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark < FUSE > R913 1-249-416-11 CARBON 1/4W R914 1-216-829-11 METAL CHIP 4.7K 1/10W 0 F901 1-532-465-32 FUSE 3.15A 250V R915 1-216-801-11 METAL CHIP 1/10W (AEP, UK, EA, HK, SP, KR, AUS, CH, E41)
  • Page 26 SA-TS22W POWER CONNECT POWER LED PIN JACK 1P SPK Ref. No. Part No. Description Remark 1-863-569-11 POWER CONNECT BOARD ********************* < CONNECTOR > * CN904 1-564-321-21 PIN, CONNECTOR (3.96mm PITCH) 2P * CN905 1-695-044-11 PIN, CONNECTOR (3.96mm PITCH) 2P ************************************************************...
  • Page 27 SA-TS22W MEMO...

  • Page 28: Revision History

    SA-TS22W REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2004.07...

Table of Contents

Save PDF