Nokia RM-596 Service Manual
Hide thumbs
Also See for RM-596:
- Service schematics (13 pages) ,
- Service manual (253 pages) ,
- Service schematics (15 pages)
Table of Contents
Advertisement
Quick Links
SERVICE MANUAL
Level 1&2
RM-596
Transceiver characteristics
Band
WCDMA HSPA 850/900/1700/1900/2100
EGSM 850/900/1800/1900
Display
3.5" AMOLED, up to 16.7 million colors, 16:9
widescreen aspect ratio, 640x360 pixel resolution
Camera
12 Mpix Carl Zeiss autofocus camera with CMOS
sensor, Xenon flash, 1280x720 25 fps HD video
recording
Operating System
Symbian^3
Connections:
HDMI connector with Dolby Digital 5.1 audio, analog
TV out with stereo audio via 3.5 mm AV connector,
Micro USB 2.0 with OTG support, Bluetooth 3.0, WLAN
802.11 b/g/n
Transceiver with BL-4D battery pack
Talk time
GSM:
Up to 12 hours
WCDMA:
Up to 5.8 hours
Note:
Talk times are dependent on network parameters
and phone settings
Nokia N8-00
RM-596
Service Manual Level 1&2
Standby
GSM:
Up to 390 hours
WCDMA:
Up to 400 hours
Advertisement
Table of Contents
Related Manuals for Nokia RM-596
Summary of Contents for Nokia RM-596
- Page 1 Nokia N8-00 RM-596 Service Manual Level 1&2 SERVICE MANUAL Level 1&2 RM-596 Transceiver characteristics Band WCDMA HSPA 850/900/1700/1900/2100 EGSM 850/900/1800/1900 Display 3.5” AMOLED, up to 16.7 million colors, 16:9 widescreen aspect ratio, 640x360 pixel resolution Camera 12 Mpix Carl Zeiss autofocus camera with CMOS...
-
Page 2: Table Of Contents
6. EXPLODED VIEW ..................................9 7. SERVICE DEVICES ..................................11 8. SOFTWARE UPDATE ................................12 9. DISASSEMBLY INSTRUCTIONS ............................. 13 10. ASSEMBLY INSTRUCTIONS..............................23 11. SOLDER COMPONENTS ................................32 Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0... - Page 3 28.6.2010 First approved version The purpose of this document is to help NOKIA service levels 1 and 2 workshop technicians to carry out service to NOKIA products. This Service Manual is to be used only by authorized NOKIA service suppliers, and the content of it is confidential. Please note that NOKIA provides also other guidance documents (e.g.
-
Page 4: Copyright
Nokia operates a policy of continuous development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused. -
Page 5: Warnings And Cautions
3. Use only approved components as specified in the parts list. 4. Ensure all components, modules screws and insulators are correctly re–fitted after servicing and alignment. 5. Ensure all cables and wires are repositioned correctly Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0... -
Page 6: Esd Protection
RM-596 Service Manual Level 1&2 3. ESD PROTECTION Nokia requires that service points have sufficient ESD protection (against static electricity) when servicing the phone. Any product of which the covers are removed must be handled with ESD protection. The SIM card can be replaced without ESD protection if the product is otherwise ready for use. -
Page 7: Care And Maintenance
All of the above suggestions apply equally to the product, battery, charger or any accessory. Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0... -
Page 8: Battery Information
Batteries’ performance is particularly limited in temperatures well below freezing. Do not dispose batteries in a fire! Dispose of batteries according to local regulations (e.g. recycling). Do not dispose as household waste. Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0... -
Page 9: Exploded View
(I0015 - I0018) ENGINE CHASSIS I0018 DC JACK EARPIECE ADHESIVE I0015 I0017 EARPIECE I0016 Only available as These parts can not be Ver. 1.0 Page 1/2 assembly reused after removal Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0... - Page 10 TYPE LABEL I0023 SIM CARD HATCH I0033 MICRO SD CARD HATCH I0034 Only available as These parts can not be Ver. 1.0 Page 2/2 assembly reused after removal Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0...
-
Page 11: Service Devices
FLS-5 Flash Device CA-101 Service Cable AC-15 Travel Charger Nokia Standard Toolkit (v2) For more information, refer to the Service Bulletin (SB-011) on Nokia Online. Supplier or manufacturer contacts for tool re-order can be found in “Recommended service SS-182 Camera Removal tool BL-4D Battery equipment”... -
Page 12: Software Update
To use the FLS-5 Flash Dongle, follow the user guide inside the sales package. Please check always for the latest version of flash software, which is available on Nokia Online. Confidential | Copyright © 2010 Nokia | All rights reserved... -
Page 13: Disassembly Instructions
Service Manual Level 1&2 9. DISASSEMBLY INSTRUCTIONS 1) Nokia N8-00 disassembly. 2) You must use the Nokia Standard To 2. You will also need the camera remov 182 and the DC plug. 3) Protect the WINDOW ASSY with protective film. - Page 14 Nokia N8-00 RM-596 Service Manual Level 1&2 wn end of the BATTERY LID. Release 8) Now the BATTERY LID can be removed. d by pulling it into direction move the BATTERY by using the 10) Open the HDMI HATCH. T TAPE.
- Page 15 Nokia N8-00 RM-596 Service Manual Level 1&2 13) Pull out and remove the HDMI HATCH. 14) Unscrew the four Torx+ size 5 screws order shown. These screws cannot be use Discard them. 15) Slide SRT-6 to the direction shown to release 16) Release also the second clip on the ot the clip holding the WINDOW ASSY.
- Page 16 Nokia N8-00 RM-596 Service Manual Level 1&2 19) Open also the LCD CONNECTOR with the SS-93 by 20) The WINDOW ASSY can now be separa lifting it from the side shown. Be careful not to damage the connector or components nearby!
- Page 17 Nokia N8-00 RM-596 Service Manual Level 1&2 25) Release the COMBO ANTENNA with the SS-93. 26) Remove the COMBO ANTENNA. 27) Unscrew the three Torx+ size 6 screws in the 28) Lift up and remove the ENGINE CHASS order shown. These screws cannot be used again.
- Page 18 Nokia N8-00 RM-596 Service Manual Level 1&2 31) Use the DC plug to lift up the DC JACK. 32) Release the EARPIECE with the SRT-6 a 33) Remove the EARPIECE with the tweezers. The 34) Remove the EARPIECE GASKET with th EARPIECE cannot be used again.
- Page 19 Nokia N8-00 RM-596 Service Manual Level 1&2 37) To separate the ENGINE BOARD from the BODY 38) The ENGINE BOARD can now be separa ASSY, lift up the shown side (1). Then pull the ENGINE BOARD to the direction shown (2).
- Page 20 Nokia N8-00 RM-596 Service Manual Level 1&2 43) To release the CAMERA, push down the camera 44) Release the IHF SPEAKER with the den removal tool SS-182 until camera retaining clips are and remove it with the tweezers. Do not released.
- Page 21 52) Remove the screw and the FIXING NUT w FIXING NUT. tweezers. 53) To release the second FIXING NUT, unscrew the 54) Remove the screw with the tweezers. Torx+ size 4 screw. Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0...
- Page 22 Nokia N8-00 RM-596 Service Manual Level 1&2 55) Remove the FIXING NUT. 56) The Nokia N8-00 disassembly is now co -END OF DISASSEMBLY- Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0...
-
Page 23: Assembly Instructions
Service Manual Level 1&2 10. ASSEMBLY INSTRUCTIONS 1) Nokia N8-00 assembly. 2) For assembling you need the Nokia Standard Toolkit version 2. 3) When inserting the CAMERA MODULE, check that 4) Place a new SUB PWB SUPPORT to the ENGINE the shown clip is on the same side as the guiding BOARD by using the shown guiding pin. - Page 24 Nokia N8-00 RM-596 Service Manual Level 1&2 7) Press the SUB PWB carefully with the SS-93. Make 8) Insert the two FIXING NUTS. sure the two clips shown are locked. 9) Note that there are two different TORX+ size 4 10) Hold the FIXING NUTS in place with your finger.
- Page 25 Nokia N8-00 RM-596 Service Manual Level 1&2 13) Push down the FLASH MODULE with the SS-93 to 14) Insert the SIM CARD HATCH fastener into the attach the three clips. BODY ASSY cavity. Then press the SIM CARD HATCH into place.
- Page 26 Nokia N8-00 RM-596 Service Manual Level 1&2 19) Remove the camera lens protective film with 20) To insert the ENGINE BOARD to the BODY ASSY, the tweezers. first insert the side where the USB CONNECTOR is located. 21) Lower down the other side of the ENGINE 22) Press the AV CONNECTOR with the SS-93 until it BOARD.
- Page 27 Nokia N8-00 RM-596 Service Manual Level 1&2 25) Remove the new EARPIECE from the protective 26) Place the EARPIECE and press it with the SS-93 to film. activate the adhesive. 27) Insert the DC JACK with the tweezers and firmly 28) Place the FRONT CAMERA BOOT ASSY.
- Page 28 Nokia N8-00 RM-596 Service Manual Level 1&2 31) Tighten the two TORX + size 6 screws to the 32) Tighten the TORX + size 6 screw to the torque of torque of 15 Ncm in the order shown. 8 Ncm.
- Page 29 Nokia N8-00 RM-596 Service Manual Level 1&2 37) Carefully place down the WINDOW ASSY. Make 38) Press the WINDOW ASSY from both sides to get sure that the connectors remain connected! the WINDOW FRAME FIXING SPRINGS locked. 39) Tighten the four TORX + size 4 screws to the 40) Remove the protective film from the TOP COVER torque of 14 Ncm in the order shown.
- Page 30 Nokia N8-00 RM-596 Service Manual Level 1&2 43) Close the HDMI HATCH and check that the TOP 44) Place the BATTERY PULL-OUT TAPE to the COVER edges are attached properly. BATTERY as shown. Press it down slightly to activate the adhesive.
- Page 31 51) Hold the BOTTOM COVER in its place and tighten 52) Nokia N8-00 assembly is now complete. the TORX + size 4 screws to the torque of 21 Ncm on both sides.
-
Page 32: Solder Components
Service Manual Level 1&2 11. SOLDER COMPONENTS S2401 S2402 S2400 F3350 X7402 V2422 S2403 V2420 G2200 F3300 V2411 V2410 X2500 BOTTOM X3300 X1650 X6700 X6702 X7403 X7404 Ver. 1.0 Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0... - Page 33 www.s-manuals.com...