Table of Contents
Advertisement
2
3
4
1. ROPS knob (locked
position)
2. Pull ROPS knob out and
rotate 90 degrees to
change roll bar position
Adjusting the Tracking
1. Disengage the blade control switch (PTO).
2. Drive to an open flat area, move the motion control
levers to the neutral locked position.
3. Move the throttle midway between fast and slow.
4. Move both motion control levers all the way forward
until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until the
machine tracks straight (Figure 58).
7. If it tracks to the left, loosen the bolts and adjust the
right stop plate rearward on the right T-slot until the
machine tracks straight (Figure 58).
8. Tighten the stop plate (Figure 58).
1
Figure 57
3. Roll bar in the upright
position
4. Roll bar in the folded
position
1. Control lever
g013441
2. Bolt
Checking the Tire Pressure
Service Interval: Every 50 hours/Monthly (whichever
Maintain the air pressure in the rear tires at 13 psi (90
kPa). Uneven tire pressure can cause uneven cut. Check
the tires when they are cold to get the most accurate
pressure reading.
Note: The front tires are semi-pneumatic tires and do
not require air pressure maintenance.
45
Figure 58
Left control lever shown
3. Stop plate
comes first)
Figure 59
G013450
Advertisement
Table of Contents
