Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Installing the Handle
Parts needed for this procedure:
4
Bolt (1/2 x 1-1/2 inches)
2
Curved washer
2
Spacer
4
Locknut (1/2 inch)
Procedure
1. Remove the two screws that hold the back cover in
place and remove the back cover (Figure 3).
Description
Bolt (1/2 x 1-1/2 inches)
Curved washer
Spacer
Locknut (1/2 inch)
SAE 30 detergent oil with an API service
classification of SH, SJ, SL, or higher
(not supplied with the mower).
No parts required
Figure 3
Qty.
4
2
Install the handle.
2
4
20 oz.
Fill the engine with oil.
(0.55 l)
–
Install the mulch plug or grass bag.
2. Attach the handle to the mower housing (Figure 4)
using the 4 bolts, 4 locknuts, 2 spacers, and 2 curved
washers in the loose parts bag.
1. Bolt (1/2 x 1-1/2 inches)
(4)
2. Curved washer (2)
Note: You can set the handle height in one of two
positions (Figure 5). Set the handle to a height that is
comfortable for you.
7
Use
Figure 4
3. Spacer (2)
4. Locknut (1/2 inch) (4)
Hide quick links:
Advertisement
Table of Contents
