Table of Contents
Advertisement
G010233
3
1
1. Anti-scalp roller
2. Bolt
Positioning the Seat
A
C
4
2
Figure 19
3. Flange Nut
4. Hole spacing
B
Figure 20
Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or lower for
maximum operator comfort.
A
g027252
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever fore or aft
secure the control in the new position.
3. Repeat the adjustment for the opposite control lever.
Pushing the Machine by Hand
Important: Always push the machine by hand. Never
tow the machine because damage may occur.
g027249
This machine has an electric brake mechanism and to push
the machine the ignition key needs to be in the Run position.
The battery needs to be charged and functioning for the
electric brake to be disengaged.
To Push the Machine
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to park
position, stop the engine, and wait for all moving parts
to stop before leaving the operating position.
3. Locate the bypass levers on the frame on both sides of
the engine.
4. Move the bypass levers forward through the key hole
and down to lock them in place as shown in
Ensure this is done for each lever.
22
B
Figure 21
(Figure
21). Tighten both bolts to
Figure 22
.
Hide quick links:
Advertisement
Table of Contents
