Installing The Mower; Replacing The Grass Deflector - Toro 74650 Operator's Manual
Hide thumbs
Also See for 74650:
- Operator's manual (52 pages) ,
- Operator's manual (56 pages) ,
- Operator's manual (56 pages)
Table of Contents
Advertisement
2
2
1
Figure 65
Mower decks with 2 blades
7. Slide the mower deck rearward to remove the mower
belt from the engine pulley.
8. Slide the mower deck out from underneath the
machine.
Note: Retain all parts for future installation.
Installing the Mower
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Lift the rear of the mower deck and guide the hanger
brackets over the rear lift rod
6. Attach the front support rod to the mower deck with
the clevis pin and hairpin cotter
7. Install the mower belt onto the engine pulley; refer to
(page
).
2
2
3
3
G005077
(Figure
64).
(Figure
63).
Replacing the Grass Deflector
Service Interval: Before each use or daily—Inspect the grass
deflector for damage.
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur. Never
operate the machine without the grass deflector,
the discharge cover, or the grass-collection system
in place.
Never operate the machine without the grass
deflector, the discharge cover, or the grass-collection
system in place.
1. Locate items shown in
2
3
5
7
1
1. Mower deck
2. Grass deflector
3. Grass-deflector bracket
4. Rod
44
Figure 66
and
Figure
4
6
G014636
Figure 66
32-inch deck
5. Spring
6. Nut (3/8 inch)
7. Short standoff
67.
Advertisement
Table of Contents
