Table of Contents
Advertisement
GEAR DRIVE SYSTEM
Brake Adjustment
Never attempt to adjust the brakes while the engine
is running. Always disengage PTO, move shift lever
into neutral position, stop engine and remove key to
prevent unintended starting.
If the tractor does not come to a complete stop when the
brake pedal is completely depressed, or if the tractor's
rear wheels can roll with the parking brake applied, the
brake is in need of adjustment. The brake disc can be
found on the right side of the transmission in the rear of
the tractor. Adjust if necessary as follows:
Looking at the transmission from the right side of the
tractor, locate the spring and brake disc (Fig. 624).
5
A
D
A. Brake disc
B. Hex nut
5-52
!
!
WARNING
D
B
C
Fig 624
C. Spring
D. Brake puck (2)
1. Loosen, but do NOT remove, the hex nut found on
the right side of the brake assembly (Fig. 000 abov).
2. Insert a feeler gauge set at .011" (.028mm) between
the brake disc and the brake puck (Fig. 625).
Fig 625
Note: If a feeler gauge is unavailable, a typical
business card is approximately .011"
(.028mm) thick.
3. Retighten the hex nut loosened earlier, leaving a
.011" (.028mm) gap between the brake disc and the
brake puck.
GT Series Tractors Service Manual
PICT-7731
Hide quick links:
Advertisement
Table of Contents
