Table of Contents
Advertisement
6.
To adjust front-to rear blade level loosen jam
nuts on front adjustable links. (Fig. 16).
7.
Rotate the bolt on front adjustable links to
change front-to rear blade level (Fig. 16).
Note:
To raise the front of the mower,
shorten the adjustable links by turning
bolt clockwise. Adjust both sides
evenly.
Figure 16
1. Adjustable link
2. Jam nut (not shown)
8.
When front-to-rear slope is correct, tighten jam
nuts. Recheck side-to-side mower level; refer to
Side-to-Side Mower Leveling, page 9.
3. Bolt
Removing the Mower
1.
Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
and turn the ignition key to "OFF" to stop the
engine. Remove the key.
2.
Raise attachment lift, turn Dial-a-Height knob
counterclockwise, all the way, and lower the
attachment lift lever to the mounting position;
refer to tractor Operator's Manual.
3.
Remove mower drive belt from engine pulley.
4.
Remove hairpin cotter, washer and link pin from
carrier lift arm and remove from attachment lift
(Fig. 17).
5.
Remove hairpin cotter and washer from front
adjustable link(s) and remove from front lift arm
(Fig. 17).
6.
Remove hairpin cotters and washers from carrier
lift arms (Fig. 17).
7.
Slide deck right, off carrier lift arms (Fig. 17).
Figure 17
1. Link pin
2. Washer 1/2"
3. Hair pin cotter–small
4. Attachment lift
8.
Raise attachment lift all the way to the latched
position. Turn the front wheels, as necessary, and
slide mower out to the the right side.
Note:
Save all hardware, washers and hairpin
cotters for use when installing deck.
Installation
5. Carrier lift arm
6. Washer 3/4"
7. Hair pin cotter–large
8. Front adjustable link
11
Advertisement
Table of Contents
