Card Configuration - Cisco 10000 Series Configuration Manual
Router line card
Hide thumbs
Also See for 10000 Series:
- Configuration manual (854 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
1-Port OC-48/STM-16 Packet over SONET Line
Card Configuration
This chapter describes procedures for configuring the Cisco 10000 series 1-Port OC-48/STM-16 Packet
over SONET line card, hereafter known as the 1-Port OC-48/STM-16 Packet over SONET line card.
The 1-Port OC-48/STM-16 Packet over SONET line card provides a trunk uplink capable of supporting
up to 2.4 Gbps full duplex throughput over a standard SONET/ITU-T Synchronous Digital
Hierarchy (SDH) interface, using a single-mode fiber with SC connectors.
This chapter contains the following sections:
•
•
•
•
•
•
•
•
•
Software Support
Table 14-1
OC-48/STM-16 Packet over SONET line card.
Table 14-1
Required PRE
PRE2
OL-8834-04
Software Support, page 14-1
Default Values, page 14-2
SDCC Default Values, page 14-2
Interface Syntax, page 14-3
Configuring the Interface, page 14-3
MAC Protocol Selection Command, page 14-4
Interface Configuration Mode Command, page 14-4
SDCC Interface Configuration Commands, page 14-5
Other Configuration Commands, page 14-7
shows the minimum Cisco IOS release on each release train that supports the 1-Port
1-Port OC-48/STM-16 Packet over SONET Line Card Software Support
Minimum Cisco IOS Releases
Cisco IOS Release 12.2(15)BX and later releases of Cisco IOS 12.2BX
Cisco Release IOS 12.3(7)XI and later releases of Cisco IOS 12.3XI
Cisco IOS Release 12.2(28)SB and later releases of Cisco IOS 12.2SB
C H A P T E R
Cisco 10000 Series Router Line Card Configuaration Guide
14
14-1
Advertisement
Chapters
Table of Contents
