Table of Contents
Advertisement
11
Run the System Setup Wizard
The System Setup Wizard starts automatically when you access
the appliance via the web-based interface (or when you run the
systemsetup command from the command-line interface.)
Start the System Setup Wizard.
Step 1
Accept the end user license agreement.
Step 2
Enter information from the
Step 3
Settings" section on page
Set anti-spam and anti-virus security settings.
Step 4
Review the configuration summary page.
Step 5
Click Install this Configuration.
Step 6
The appliance may not appear to have accepted your
configuration or be performing the installation. This is
because you have changed the IP address, but the
installation is underway.
If you temporarily changed the IP address of your
Step 7
computer as described in the
Your IP Address for Remote Access" section on page
change the IP address settings back to the original
values.
Ensure that your laptop and the appliance are
Step 8
connected to the network.
Log back in to the appliance with the username admin
Step 9
and the new password that you set in the System Setup
Wizard.
The Cisco C690 Email Security Appliance uses a
self-signed certificate that may trigger a warning from
your web browser. You can simply accept the certificate
and ignore this warning.
Step 10 Write down your new administrator password and
keep it in a safe place.
"Document Network
3.
"Temporarily Change
6,
11
Advertisement
Table of Contents
