hit counter script

Advertisement

In the interests of user-safety (Required by safety regulations in some countries) the set should be restored to its
original condition and only parts identical to those specified should be used.
» ELECTRICAL SPECIFICATIONS ......................................................................................................... 1
» IMPORTANT SERVICE SAFETY PRECAUTION ................................................................................. 2
» LOCATION OF USER'S CONTROL ..................................................................................................... 6
» INSTALLATION AND SERVICE INSTRUCTIONS ................................................................................ 7
» CHASSIS LAYOUT ............................................................................................................................. 13
» BLOCK DIAGRAM .............................................................................................................................. 14
» SCHEMATIC DIAGRAMS ................................................................................................................... 15
» PRINTED WIRING BOARD ASSEMBLIES ........................................................................................ 21
» REPLACEMENT PARTS LIST ............................................................................................................ 24
» PACKING OF THE SET ...................................................................................................................... 31
POWER INPUT .................................................... 120 V AC 60 Hz
POWER RATING ................................................................... 53 W
PICTURE SIZE ............................................. 580cm
CONVERGENCE ............................................................. Magnetic
SWEEP DEFLECTION .................................................... Magnetic
FOCUS ............................................... Hi-Bi-Potential Electrostatic
INTERMEDIATE FREQUENCIES
Picture IF Carrier Frequency ..................................... 45.75 MHz
Sound IF Carrier Frequency ...................................... 41.25 MHz
Color Sub-Carrier Frequency .................................... 42.17 MHz
AUDIO POWER
OUTPUT RATING ................................ 0.9W (at 10% distortion)

SHARP CORPORATION

SERVICE MANUAL

13N-M100B/150B
CN13M10B
MODELS
CONTENTS
ELECTRICAL SPECIFICATIONS
SPEAKER
SIZE ...................................................................... 8 cm (Round)
VOICE COIL IMPEDANCE ............................. 32 ohm at 400 Hz
2
(89.8sq inch)
ANTENNA INPUT IMPEDANCE
VHF/UHF ..................................................... 75 ohm Unbalanced
TUNING RANGES
VHF-Channels ............................................................... 2 thru 13
UHF-Channels ............................................................ 14 thru 69
CATV Channels ........................................................... 1 thru 125
(Nominal)
Specifications are subject to change without
prior notice.
This document has been published to be used for after
sales service only.
The contents are subject to change without notice.
1
COLOR TELEVISION
Chassis No. SN-010
13N-M100B/150B
CN13M10B
SX0K513N-M100
Page
(EIA, Channel Plan U.S.A.)

Advertisement

Table of Contents
loading

Summary of Contents for Sharp 13N-M100B

  • Page 1: Table Of Contents

    13N-M100B/150B CN13M10B SERVICE MANUAL SX0K513N-M100 COLOR TELEVISION Chassis No. SN-010 13N-M100B/150B CN13M10B MODELS In the interests of user-safety (Required by safety regulations in some countries) the set should be restored to its original condition and only parts identical to those specified should be used.
  • Page 2: Important Service Safety Precaution

    13N-M100B/150B CN13M10B IMPORTANT SERVICE SAFETY PRECAUTION Ë Service work should be performed only by qualified service technicians who are thoroughly familiar with all safety checks and the servicing guidelines which follow: WARNING X-RADIATION AND HIGH VOLTAGE LIMITS 1. For continued safety, no modification of any circuit 1.
  • Page 3: Safety Notice

    13N-M100B/150B CN13M10B IMPORTANT SERVICE SAFETY PRECAUTION (Continued) • Connect the resistor connection to all exposed metal BEFORE RETURNING THE RECEIVER parts having a return to the chassis (antenna, metal (Fire & Shock Hazard) cabinet, screw heads, knobs and control shafts, escutcheon and etc.) and measure the AC voltage...
  • Page 4 13N-M100B/150B CN13M10B PRECAUTIONS A PRENDRE LORS DE LA REPARATION Ne peut effectuer la réparation qu' un technicien spécialisé qui s'est parfaitement accoutumé à toute vérification de sécurité et aux conseils suivants. AVERTISSEMENT LIMITES DES RADIATIONS X ET DE LA HAUTE TENSION 1.
  • Page 5 13N-M100B/150B CN13M10B PRECAUTIONS A PRENDRE LORS DE LA REPARATION (Suite) • Toucher avec la sonde d'essai les pièces métalliques VERIFICATIONS CONTRE L'INCEN-DIE ET exposées qui présentent une voie de retour au LE CHOC ELECTRIQUE châssis (antenne, coffret métallique, tête des vis, Avant de rendre le récepteur à...
  • Page 6: Location Of User's Control

    13N-M100B/150B CN13M10B LOCATION OF USER'S CONTROL Front Panel POWER – VOL + VIDEO IN AUDIO MENU VIDEO/AUDIO IN TERMINALS SENSOR AREA FOR REMOTE CONTROL POWER – VOL + MENU POWER Press → On. Press again → Off. CHANNEL UP/DOWN – MENU VOLUME UP/DOWN (') Selects next higher channel.
  • Page 7: Installation And Service Instructions

    13N-M100B/150B CN13M10B INSTALLATION AND SERVICE INSTRUCTIONS Note: (1) When performing any adjustments to resistor controls and transformers use non-metallic screwdrivers or TV alignment tools. (2) Before performing adjustments, the TV set must be on at least 15 minutes. HIGH VOLTAGE CHECK CIRCUIT PROTECTION The receiver is protected by a 4.0A fuse (F701),...
  • Page 8 13N-M100B/150B CN13M10B For adjustments of this model, the bus data is converted to various analog signals by the D/A converter circuit. Note: There are still a few analog adjustments in this series such as focus and master screen voltage. Follow the steps below whenever the service adjusment is required.
  • Page 9 R/B ANGLE 00-0F H BLK R 00-0F H BLK L 00-0F * Must be "B0" for 13N-M100B/150B, "A0" for CN13M10B Table - A Below are the ranges and initial values for each adjustment and in each categories. DATA SERVICE ADJUSTMENT CONTENTS...
  • Page 10 13N-M100B/150B CN13M10B Holding down both the Vol-up/Ch-down buttons on the TV set at service mode for more than 2 seconds will automatically write the above initial values into IC2101. ADJUSTMENT PART REPLACED NOTES NECESSARY UNNECESSARY IC2001 Data is stored in IC2101.
  • Page 11: 13N-M100B/150B

    13N-M100B/150B CN13M10B Ë SERVICE ADJUSTMENT Note: Before making the service adjustment, make the 6. Adjust the master screen control untill the raster bus data settings. darkens to the point where raster is barely seen. +B Adjustment 7. Adjust the service adjustment "S05" red, "S06" green, "S07"...
  • Page 12 13N-M100B/150B CN13M10B Vertical-Size, V-Linearity, V-S Correction Adjustment 1. Receive a good local channel. 2. Enter the service mode DEF category and select the adjustment "D02" for Vertical Size, "D05" for V- Linearity and "D06" for V-S Correction Adjustment. 3. Set in order "D05" for V-Linearity, "D06" for V-S Correction and set the data to get the best linearity.
  • Page 13: Chassis Layout

    13N-M100B/150B CN13M10B CHASSIS LAYOUT PWB-B PWB-A...
  • Page 14: Block Diagram

    13N-M100B/150B CN13M10B BLOCK DIAGRAM...
  • Page 15: Schematic Diagrams

    13N-M100B/150B CN13M10B DESCRIPTION OF SCHEMATIC DIAGRAM WAVEFORM MEASUREMENT CONDITIONS: NOTES: 1. Photographs taken on a standard gated color bar 1. The unit of resistance "ohm" is omitted. (K=k Ω =1000 Ω , M=M Ω ) signal, the tint setting adjusted for proper color. The wave shapes at the red, green and blue cathodes of 2.
  • Page 16 13N-M100B/150B CN13M10B MODELS 13N-M100B/150B SCHEMATIC DIAGRAM: MAIN Unit...
  • Page 17 13N-M100B/150B CN13M10B MODEL CN13M10B SCHEMATIC DIAGRAM: MAIN Unit...
  • Page 18 13N-M100B/150B CN13M10B SCHEMATIC DIAGRAM: CRT Unit...
  • Page 19: Printed Wiring Board Assemblies

    13N-M100B/150B CN13M10B PRINTED WIRING BOARD ASSEMBLIES PWB-B: CRT Unit (Wiring Side) PWB-B: CRT Unit (Chip Parts Side)
  • Page 20 13N-M100B/150B CN13M10B PWB-A: MAIN Unit (Wiring Side)
  • Page 21 13N-M100B/150B CN13M10B PWB-A: MAIN Unit (Chip Parts Side)
  • Page 22: Replacement Parts List

    4. DESCRIPTION in USA: Contact your nearest SHARP Parts Distributor to order. in CANADA: Contact SHARP Electronics of Canada Limited For location of SHARP Parts Distributor, Please call Toll- Phone (416) 890-2100 Free; 1-800-BE-SHARP MARK: SPARE PARTS-DELIVERY SECTION MARQUE: SECTION LIVRAISON DES PIECES DE RECHANGE...
  • Page 23 RH-DX0487CEZZ J Diode å Q701 VS2SK2645++-1 J K2645++ (CN13M10B) å RH-DX0302CEZZ VS2SK2708//1E RH-DX0468CEZZ VSSTP6NC60F-1 å Q701 VSSPP04N60C-1 J SPP04N60 (13N-M100B/150B) AH VHDD1NS4///-1 VSSPP07N60C-1 RH-DX0513CEZZ ' å D717 RH-EX0616GEZZ J Zener Diode, 5.6V VS2SK2708//1E å D725 RH-DX0131CEZZ J Diode D726 RH-DX0475CEZZ...
  • Page 24 13N-M100B/150B CN13M10B Ref. No. Part No. Description Code Ref. No. Part No. Description Code PWB-A: DUNTKA358WEV0 (13N-M100B/150B) C516 VCKYCY1HB222K J 2200p 50V Ceramic PWB-A: DUNTKA358WEV3 (CN13M10B) C517 VCEA0A1CW226M J 22 C520 VCEA0A1HW107M J 100 MAIN UNIT (Continued) C530 VCFYFA1HA334J J 0.33...
  • Page 25 13N-M100B/150B CN13M10B Ref. No. Part No. Description Code Ref. No. Part No. Description Code PWB-A: DUNTKA358WEV0 (13N-M100B/150B) R513 VRD-RM2HD102J J 1.0k 1/2W Carbon PWB-A: DUNTKA358WEV3 (CN13M10B) R514 VRD-RM2HD1R0J J 1.0 1/2W Carbon R515 VRS-VU3AE391J J 390 1W M-Ox. MAIN UNIT (Continued)
  • Page 26 13N-M100B/150B CN13M10B Ref. No. Part No. Description Code Ref. No. Part No. Description Code PWB-A: DUNTKA358WEV0 (13N-M100B/150B) PWB-A: DUNTKA358WEV3 (CN13M10B) QSW-K0079GEZZ S2504 QSW-K0202PEZZ R CH-Down MAIN UNIT (Continued) R2006 VRN-MD2AL103J J 10k 1/10W M-Film QSW-K0079GEZZ R2008 VRN-MD2AL333J J 33k 1/10W M-Film...
  • Page 27: Miscellaneous Parts

    13N-M100B/150B CN13M10B Ref. No. Part No. Description Code Ref. No. Part No. Description Code PWB-B: DUNTKA359WEV0 (13N-M100B/150B) MISCELLANEOUS PARTS PWB-B: DUNTKA359WEV3 (CN13M10B) CRT UNIT ACC701 QACCD3090CESA J AC Cord å TRANSISTORS (13N-M100B, CN13M10B) Q852 VSBF422////-1 J BF422 QACCD3064CESA VS2SC2229O/1E QACCD3060CESA...
  • Page 28: Packing Parts

    (CN13M10B) Not Available – Front Cabinet — GCOVA0078PEKA R R/C Cover JBTN-0306PESA R Button (13N-M100B, CN13M10B) JBTN-0306PESB R Button (13N-M150B) CCABB2309WEV0 R Rear Cabinet (13N-M100B) AW CCABB2309WEV1 R Rear Cabinet (13N-M150B) AW CCABB2325WEV0 R Rear Cabinet (CN13M10B) AW 1 1-1...
  • Page 29: Packing Of The Set

    13N-M100B/150B CN13M10B PACKING OF THE SET Polyethylene Bag Operation Manual Batteries Wrapping Paper Buffer Material FRONT Packing Case Use 22 staples to fix the packing case. REAR MARK : Not replacement items.
  • Page 30 13N-M100B/150B CN13M10B COPYRIGHT © 2000 BY SHARP CORPORATION ALL RIGHTS RESERVED. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of the publisher.

This manual is also suitable for:

13n-m150bCn13m10b

Table of Contents