4 HUMAN INTERFACES
The software prompts for a template password. This password must be at least four characters in length.
3.
Enter and re-enter the new password, then click OK to continue.
The settings file template is now secured with password protection.
When templates are created for online settings, the password is added during the initial template creation step. It
does not need to be added after the template is created.
NOTE
d) VIEWING THE SETTINGS TEMPLATE
Once all necessary settings are specified for viewing, users are able to view the settings template on the online device or
settings file. There are two ways to specify the settings view with the settings template feature:
•
Display only those settings available for editing
•
Display all settings, with settings not available for editing greyed-out
Use the following procedure to only display settings available for editing:
1.
Select an installed device or a settings file from the tree menu on the left of the EnerVista UR Setup main screen.
2.
Apply the template by selecting the Template Mode > View In Template Mode option.
3.
Enter the template password then click OK to apply the template.
Once the template has been applied, users are limited to view and edit the settings specified by the template. The effect of
applying the template to the phase time overcurrent settings is shown below.
Phase time overcurrent settings window without template applied.
Figure 4–4: APPLYING TEMPLATES VIA THE VIEW IN TEMPLATE MODE COMMAND
GE Multilin
C70 Capacitor Bank Protection and Control System
4.2 EXTENDED ENERVISTA UR SETUP FEATURES
Phase time overcurrent window with template applied via
the
Template Mode > View In Template Mode
The template specifies that only the
Pickup
settings be available.
4
command.
and
Curve
842858A1.CDR
4-7