空氣清新機 使用說明書 “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. *The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm which is measured around the center of a room with the “high-density plasmacluster 7000”...
Page 2
Please read before operating your new Air Purifier The air purifier draws in room air from the air intake, passes the air through a Pre- Filter and a HEPA Filter inside of the unit, then discharges the air through the air outlet.
*When air is drawn through the filter system. Thank you for purchasing the SHARP Air Purifier. Please read this manual carefully. Before using this product, be sure to read the section: “Important Safety Instructions.”...
• Be cautious when cleaning the unit. Corrosive cleansers may damage the exterior. • Only a Sharp Authorized Service Centre should service this air purifier. Contact the nearest Service Centre for any problems, adjustments, or repairs.
CAUTIONS CONCERNING OPERATION • Do not block the air intake and/or air outlet. • Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into contact with steam. • Do not lay the unit down when using. •...
PART NAMES FRONT BACK Main Unit HEPA Filter Air Outlet Upper Tabs Fan Speed Indicator Lights (green) Back Panel (Pre-Filter) MODE Button / LIGHT ON/OFF Button (Press 3 sec.) Bottom Tabs Plasmacluster Ion Indicator Light (blue) Handle Plasmacluster Ion ON/OFF Button Date Label POWER ON/OFF Button Power Cord...
FILTER INSTALLATION Be sure to remove the power plug from the wall outlet. To maintain the quality of the filter, it is installed in the main unit and packed in plastic bag. Be sure to remove the filter from the plastic bag before using the unit. Replace the Back Panel to the Remove the Back Panel.
OPERATION CLEAN AIR START STOP • Select the desired fan speed. • Unless the power cord has been unplugged, the operation starts in the previous mode it was operated in. CLEAN ION SHOWER Releases high-density Plasmacluster ions and discharges strong air flow for 60 minutes. START NOTE •...
Page 9
Light Control You can set the Plasmacluster Ion Indicator to OFF when the Plasmacluster Ion Indicator is bright. NOTE • When the unit starts operation, the more than more than Plasmacluster Ion Indicator always 3 sec. 3 sec. lights. • In SLEEP mode, Light Control button doesn’t operate.
CARE AND MAINTENANCE To maintain optimum performance of this air purifier, please clean the unit including the filter periodically. Be sure to disconnect the power cord from the wall outlet before performing any maintenance. BACK PANEL (Pre-filter) Gently remove dust from the back panel by using a vacuum cleaner attachment or similar tool.
Be sure to remove the power plug from the wall outlet. FILTER REPLACEMENT GUIDELINES Replacement timing About 2 years after operating Do not wash and reuse the filter The filter life and replacement period are based on the condition of smoking 5 cigarettes per day and the dust collection power is reduced by half compared with that of new filter.
TROUBLESHOOTING Before calling for services, please review the list below, since the problem may not be a unit malfunction . SYMPTOM REMEDY (not a malfunction) Dust and smoke are not removed. • Clean or replace the filter if they appear to be heavily soiled.
SPECIFICATIONS Power Supply 220V 50Hz Fan Speed SLEEP Speed Rated Power (W) Operation Airflow (m /hr) Applicable Floor Area (m High density Plasmacluster ion recommended room size (m Cord Length (m) Dimensions (mm) 400(W) x 182(D) x 463(H) Weight (kg) *1 Size of a room which is appropriate for operating the unit at maximum fan speed.