D-Link DAP1522 Configuration

Dualband technology, up to 300 mbps in each frequency band

Hide thumbs Also See for DAP1522:

Download this manual See also: User Manual

Manual Radio Configuration

This article describes how to manually configure a DAP1522 Rev B. for a competition

Configure computer IP

1. Click Start >> Control Panel

Start >> Control Panel to open the Control Panel. Then click View network status

and tasks

and tasks.

2. Select Change Adapter Settings.

Change Adapter Settings.

3. Right-click

Right-click on the appropriate adapter (typically Local Area Connection) and select

Properties.

4. Click on the Internet Protocol Version 4

5. Select Use the following IP address

Use the following IP address, then enter the IP 192.168.0.51

255.0.0.0.

255.0.0.0. Then click OK

Manual Radio Configuration Last Updated: 01-06-2017

Internet Protocol Version 4 line to highlight it, then click Properties

OK.

View network status

Properties.

192.168.0.51 and the Subnet Mask

Page 1

Page 1 Manual Radio Configuration Manual Radio Configuration Manual Radio Configuration This article describes how to manually configure a DAP1522 Rev B. for a competition Configure computer IP Configure computer IP 1. Click Start >> Control Panel Start >> Control Panel to open the Control Panel. Then click View network status...
Page 2 Manual Radio Configuration Reset the DAP1522 Reset the DAP1522 Reset your DAP1522 to factory settings using the following procedure: 1. Switch your D-Link unit to Bridge Bridge mode using the switch on the back (the wireless bridge should always be in bridge mode at competition) 2.
Page 3 Manual Radio Configuration • Password = blank Click on the Setup Setup tab on the top menu bar. Click on the Wireless Wireless tab on the left side of the page. Configure Wireless Settings Configure Wireless Settings Configure the wireless settings: 1.
Page 4 Manual Radio Configuration Configure Network Settings Configure Network Settings Click Network Settings Network Settings from the left sidebar. 1. Set the IP to 10.xx.yy.1 where XXYY is your team number 2. Set the Subnet Mask to 255.0.0.0 3. Set the Default Gateway to 10.xx.yy.4 4.