Testing A Program - Siemens SINUMERIK 840D SL Operating Manual
Hide thumbs
Also See for SINUMERIK 840D SL:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
4.3
Testing a program
When testing a program, the system can interrupt the machining of the workpiece after each
program block, which triggers a movement or auxiliary function on the machine. In this way,
you can control the machining result block-by-block during the initial execution of a program
on the machine.
Note
Settings for the automatic mode
Rapid traverse reduction and dry run feed rate are available to run-in or to test a program.
Move by single block
In "Program control" you may select from among several types of block processing:
SB mode
SB1 Single block,
coarse
SB2 Data block
SB3 Single block,
fine
Precondition
A program must be selected for execution in "AUTO" or "MDA" mode.
Milling
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
4.
Place the cursor on the desired program.
5.
Press the "Select" softkey.
The program is selected.
When the program has been successfully selected, an automatic
changeover to the "Machine" operating area occurs.
Scope
The machining stops after every machine block (except for cycles)
The machining stops after every block, i.e. also for data blocks (except for
cycles)
The machining stops after every machine block (also in cycles)
Machining the workpiece
4.3 Testing a program
147
Advertisement
Table of Contents
