Safety Precautions General Guide Lines When servicing, observe the original lead dress. If a short circuit is found, replace all parts which have been overheated or damaged by the short circuit. After servicing, see to it that all the protective devices such as insulation barriers, insulation papers shields are properly installed.
Prevention of Electrostatic Discharge (ESD) to Electrostatically Sensitive (ES) Devices Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called Electrostatically Sensitive (ES) Devices. Examples of typical ES devices are integrated circuits and some field-effect transistors and semiconductor "chip"...
About lead free solder (PbF) Note: Lead is listed as (Pb) in the periodic table of elements. In the information below, Pb will refer to Lead solder, and PbF will refer to Lead Free Solder. The Lead Free Solder used in our manufacturing process and discussed below is (Sn+Ag+Cu). That is Tin (Sn), Silver (Ag) and Copper (Cu) although other types are available.
Service Hints How to remove the Pedestal assembly Lay the main unit face down. (see Fig.5) Fig.5 Remove the 2 fixing screws and hinge cover. (see Fig.6) Remove the 8 fixing screws and the pedestal assembly. (see Fig.7) SCREWS Fig.6 Fig.7 How to remove the backcover Remove the 2 fixing screws and hinge cover.
Chassis Board Layout KEY CONTROL K-BOARD A-BOARD P-BOARD H-BOARD V-BOARD B-BOARD Board Name Function A-Board Main Board B-Board Tuner H-Board AV3 Terminal Key Control Key Control K-Board Mains Input, Power Switch P-Board Power Supply V-Board Remote Receiver, LED IR, Bats Setting Inspection Voltage Confirmation Confirm the following voltages:...
(-/v) button on the TV set. To exit Self Check, switch off the TV set at the power button. O.K. O.K. O.K. AVSW O.K. O.K. O.K. TX-32LE60F TX-32LE60P TX-26LE60F TX-26LE60P OPTION 1 OPTION 2 OPTION 3 OPTION 4 OPTION 5...
Adjustment Method How to enter Service 1 • Set the Bass to maximum position, set the Treble to minimum position then keep pressing the INDEX button on the remote control and press the down button (-/v) on the TV set, this will place the TV set into the Service Mode 1. Key Command •...
JK3001 TO LCD PANEL HP RIGHT HP LEFT CVBS OUT CVBS IN R IN/C IN G IN B IN L IN R IN AV2 L OUT L OUT AV2 R OUT R OUT CVBS OUT CVBS IN R IN G IN B IN L IN R IN...
Page 11
COMP VREF SIGNAL24V D851 MAIN IN D852 D853 AUD12_16 Q873 LCF´S LCF´S LCF´S...
Schematic Diagrams IMPORTANT SAFETY NOTICE Components identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturers' specified parts. NOTE RESISTOR All resistors are carbon ¼W resistor, unless marked otherwise. Unit of resistance is OHM (Ω) (k=1,000, M=1,000,000) CAPACITORS All capacitors are ceramic 50V unless marked otherwise.