Assigning Vsan Membership For Islb Initiators - Cisco MDS 9000 series Configuration Manual
Nx-os ip services multilayer switches
Hide thumbs
Also See for MDS 9000 series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Configuring iSLB
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 2
switch(config)# islb save-initiator
name iqn.1987-02.com.cisco.initiator
switch(config)# islb save-initiator
10.10.100.11
switch(config)# iscsi save-initiator
ip-address 2001:0DB8:800:200C::417A
switch(config)# islb save-initiator
Step 3
switch(config)# exit
switch#
Step 4
switch# copy running-config
startup-config
Assigning VSAN Membership for iSLB Initiators
Individual iSLB hosts can be configured to be in a specific VSAN (similar to the DPVM feature for Fibre
Channel; see Cisco MDS 9000 Family NX-OS Fabric Configuration Guidefor more information. The
specified VSAN overrides the iSCSI interface VSAN membership.
Specifying the iSLB initiator VSAN is the same as for an iSCSI initiator. See the
Note
for iSCSI" section on page
To assign VSAN membership for iSLB initiators, follow these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# islb initiator ip-address
10.1.1.3
switch(config-islb-init)#
Step 3
switch(config-islb-init)# vsan 3
switch(config-islb-init)# no vsan 3
When an iSLB initiator is configured in any other VSAN (other than VSAN 1, the default VSAN), for
Note
example VSAN 2, the initiator is automatically removed from VSAN 1. If you also want it to be present
in VSAN 1, you must explicitly configure the initiator in VSAN 1.
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
4-44
Purpose
Saves the nWWNs and pWWNs that have
automatically been assigned to the iSLB initiator
whose name is specified.
Saves the nWWNs and pWWNs that have
automatically been assigned to the iSLB initiator
whose IPv4 address is specified.
Saves the nWWNs and pWWNs that have
automatically been assigned to the iSCSI initiator
whose IPv6 unicast address is specified.
Saves the nWWNs and pWWNs that have
automatically been assigned to all the iSLB initiators.
Returns to EXEC mode.
Saves the nWWN/pWWN mapping configuration
across system reboots.
4-17.
Purpose
Enters configuration mode.
Configures an iSLB initiator using its IPv4 address
and enters iSLB initiator configuration submode.
Assigns the iSLB initiator node to a specified VSAN.
Note
Removes the iSLB initiator from the specified
VSAN.
Chapter 4
"VSAN Membership
You can assign this host to one or more
VSANs.
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)
Configuring iSCSI
Advertisement
Table of Contents
