Iscsi Interface Vsan-Membership - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

Table of Contents

iscsi interface vsan-membership

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

iscsi interface vsan-membership

To configure VSAN membership for iSCSI interfaces, use the iscsi interface vsan-membership

command. Use the no form of this command to disable this feature or to revert to factory defaults.

Syntax Description

This command has no arguments or keywords.

Command Modes

Configuration mode.

Command History

Usage Guidelines

If the iscsi interface vsan-membership command is disabled, you will not be able to configure iSCSI

VSAN membership.

Changing the VSAN membership, the forwarding mode, and the authentication of an iSCSI interface that

is part of an iSLB VRRP group impacts load balancing on the interface.

For additional information, refer to the "Configuring iSCSI" chapter of the Cisco MDS 9000 Family CLI

Configuration Guide.

This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class

BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.

The following command enables the iSCSI interface VSAN membership.

switch# config terminal

switch(config)# iscsi interface vsan-membership

The following command disables the iSCSI interface VSAN membership (default).

switch(config)# no iscsi interface vsan-membership

Related Commands

Cisco MDS 9000 Family Command Reference

iscsi interface vsan-membership

no iscsi interface vsan-membership

Modification

This command was introduced.

OL-18089-01, Cisco MDS NX-OS Release 4.x