Special-Frame - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

Table of Contents

special-frame

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

special-frame

To enable or disable special frames for the FCIP interface, use the special-frame command. To disable

the passive mode for the FCIP interface, use the no form of the command.

Syntax Description

peer-wwn pwwn-id

profile-id profile-number

Command Modes

Interface configuration submode.

Command History

Usage Guidelines

Access this command from the

When a new TCP connection is established, an FCIP special frame (if enabled) makes one round trip

from the FCIP profile and initiates the TCP connect operation to the FCIP profile receiving the TCP

connect request and back. Use these frames to identify the FCIP link endpoints, to learn about the critical

parameters shared by Fibre Channel and FCIP profile pairs involved in the FCIP link, and to perform

configuration discovery.

The following example configures the special frames.

switch# config terminal

switch(config)# interface fcip 1

switch(config)# special-frame peer-pwwn 11:11:11:11:11:11:11:11

switch(config)# special-frame peer-pwwn 22:22:22:22:22:22:22:22 profile-id 10

Related Commands

show interface fcip

Cisco MDS 9000 Family Command Reference

special-frame peer-wwn pwwn-id [profile-id profile-number]

no special-frame peer-wwn pwwn-id

Specifies the peer WWN ID for special frames.

(Optional) Specifies the peer profile ID. The range is 1 to 255.

Modification

This command was introduced.

Displays an interface configuration for a specified FCIP interface.

switch(config-if)#

OL-18089-01, Cisco MDS NX-OS Release 4.x