Switchport Owner - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

Table of Contents

switchport owner

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

switchport owner

To configure the owner string on the port, use the switchport owner command. To disable this feature,

use the no form of the command.

Syntax Description

Command Modes

Interface Configuration mode.

Command History

NX-OS 4.1(3)

Usage Guidelines

The following example shows how to configure the owner string on the port:

switch# config t

Enter configuration commands, one per line. End with CNTL/Z.

Switch (config)# interface fc1/1

Switch (config-if)# switchport owner used_by_fc_admin

switch(config-if)#

The following example shows how to remove the owner string from the port:

switch# config t

Enter configuration commands, one per line. End with CNTL/Z.

Switch (config)# interface fc1/1

Switch (config-if)# no switchport owner

Related Commands

show interface

Cisco MDS 9000 Family Command Reference

switchport owner [owner]

no switchport owner

Specifies the owner. The maximum length of the string is 80 characters.

Modification

This command was introduced.

Displays an interface configuration for a specified interface.

OL-18089-01, Cisco MDS NX-OS Release 4.x