Qos Service - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

Table of Contents

qos service

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

To apply a service policy, use the qos service command in configuration mode. To remove a

previously-configured class, use the no form of the command.

Syntax Description

policy policy-name

vsan vsan-id

Command Modes

Configuration mode.

Command History

Usage Guidelines

You can access this command only if you enable the QoS data traffic feature using the qos enable

The following example applies a configured policy to VSAN 3.

switch(config)# qos service policy MyPolicy vsan 3

Operation in progress. Please check policy-map parameters

The following example deletes a configured policy that was applied to VSAN 7.

switch(config)# no qos service policy OldPolicy vsan 7

Operation in progress. Please check policy-map parameters

Related Commands

Cisco MDS 9000 Family Command Reference

qos service policy policy-name vsan vsan-id

no qos service policy policy-name vsan vsan-id

Modification

This command was introduced.

Displays configured QoS information.

Associates a policy map with the VSAN.

Specifies the VSAN ID. The range is 1 to 4093.

OL-18089-01 Cisco MDS NX-OS Release 4.x