Ip Address (Fcip Profile Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual
Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Configuration manual (700 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
ip address (FCIP profile configuration submode)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ip address (FCIP profile configuration submode)
To assign the local IP address of a Gigabit Ethernet interface to the FCIP profile, use the ip address
command. To remove the IP address, use the no form of the command.
Syntax Description
address
Defaults
Disabled.
Command Modes
FCIP profile configuration submode.
Command History
Release
1.3(1)
Usage Guidelines
To create a FCIP profile, you must assign a local IP address of a Gigabit Ethernet interface to the FCIP
profile.
Examples
The following example assigns the local IP address of a Gigabit Ethernet interface to the FCIP profile:
switch# config terminal
switch(config)# fcip profile 5
switch(config-profile)# ip address 209.165.200.226
Related Commands
Command
show fcip profile
interface fcip
interface_number
use-profile profile-id
show interface fcip
Cisco MDS 9000 Family Command Reference
11-46
ip address address
no ip address address
Specifies the IP address.
Modification
This command was introduced.
Description
Displays information about the FCIP profile.
Configures the interface using an existing profile ID from 1 to 255.
Displays an interface configuration for a specified FCIP interface.
Chapter 11
I Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x
Advertisement
Table of Contents
