Cabling Distance; How To Clear The Switch Ip Address And Configuration; How To Recover Passwords - Cisco IE 3000 Hardware Installation Manual
Hide thumbs
Also See for IE 3000:
- Software configuration manual (760 pages) ,
- Hardware installation manual (170 pages) ,
- Getting started manual (32 pages)
Table of Contents
Advertisement
Chapter 3
Troubleshooting
Cabling Distance
If the port statistics show excessive FCS, late-collision, or alignment errors, verify that the cable distance
from the switch to the connected device meets the recommended guidelines. See the
Connectors" section on page C-1
How to Clear the Switch IP Address and Configuration
Follow these steps to return your switch to the factory default settings. These are reasons why you might
want to reset the switch:
•
•
•
Resetting the switch deletes the configuration and reboots the switch.
Caution
To reset the password on the switch:
1.
2.
3.
After the switch restarts, continue to run Express Setup.
The switch now behaves like an unconfigured switch. You can configure the switch by using Express
Setup as described in the getting started guide that is included with the switch. You can also configure
the switch by using the CLI setup procedure described in
CLI-Based Setup Program."
How to Recover Passwords
Password recovery is a feature that a system administrator can enable or disable. If password recovery
is disabled, the only way to recover from a lost or forgotten password is to clear the switch configuration
entirely. For this procedure, see the
page
The switch software configuration guide provides details about enabling and disabling the password
recovery feature and the procedure for recovering passwords.
You installed the switch in your network and cannot connect to it because you assigned the wrong
IP address.
You want to clear all configurations from the switch and assign a new IP address.
You want to reset the password on the switch.
Power off the switch.
Power on the switch, and at the same time, press and hold down the Express Setup button until all
the system LEDs turn red.
Release the Express Setup button, and the switch continues to boot.
3-5.
How to Clear the Switch IP Address and Configuration
for cabling guidelines.
Appendix D, "Configuring the Switch with the
"How to Clear the Switch IP Address and Configuration" section on
Cisco IE 3000 Switch Hardware Installation Guide
"Cable and
3-5
- Quick Links:
- Power Converter (Optional)
Hide quick links:
Advertisement
Table of Contents
