hit counter script

Connecting The Power Converter To An Ac Power Source; Preparing The Ac Power Cord; Connecting The Ac Power Cord To The Power Converter - Cisco IE 3000 Hardware Installation Manual

Table of Contents

Advertisement

Chapter 2
Switch Installation
Follow these steps to connect DC power from the power converter to the switch module.
Locate the DC power clip in the power converter accessory kit.
Step 1
Position the power clip so that the two-pin connector is over the power converter and the four-pin
Step 2
connector is over the switch Pwr A connector, and then slide the power clip into these two connectors.
See
Figure 2-41
1
1
2
Step 3
Use a ratcheting torque flathead screwdriver to tighten the captive screw to 2.2 in-lb (0.25 Nm).
Do not over-torque the power and relay connector captive screws. The torque should not exceed 2.2 in-lb
Caution
(0.25 Nm).

Connecting the Power Converter to an AC Power Source

These sections describe the steps required to connect the power converter to an AC power source:

Preparing the AC Power Cord

To connect the power converter to an AC power source, you need an AC power cord. Power cord
connector types and standards vary by country. Power-cord wiring color codes also vary by country. You
must to have a qualified electrician select, prepare, and install the appropriate power cord to the power
supply.
Figure
2-41.
Connecting Wires to the Power Converter DC Output Terminal Block
3
2
24V
, 2.1 A
Rtn Ou
t (-)
Pw r Ou
t (+)
DC OK
1
2
N /
L /
1
3
100 -240
V~, 50-6
125 -250
0Hz /
V
, 1.25 A
MAX
2
4
DC power clip
Two-pin connector on the power convertor
Preparing the AC Power Cord, page 2-51
Connecting the AC Power Cord to the Power Converter, page 2-52
5
6
7
8
3
Four-pin connector on the switch
Cisco IE 3000 Switch Hardware Installation Guide
Connecting the Switch to the Power Converter
2-51

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents