Preparing For Installation; Warnings - Cisco IE 3000 Hardware Installation Manual
Hide thumbs
Also See for IE 3000:
- Software configuration manual (760 pages) ,
- Hardware installation manual (170 pages) ,
- Getting started manual (32 pages)
Table of Contents
Advertisement
Preparing for Installation
Warnings
These warnings are translated into several languages in the Regulatory Compliance and Safety
Information Guide.
Warning
Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals. Statement 43
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Read the installation instructions before you connect the system to its power source. Statement 1004
Warning
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Warning
For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection.
10/100/1000 Ethernet Statement 1044
Cisco IE 3000 Switch Hardware Installation Guide
B-2
Appendix B
Installation In a Hazardous Environment
- Quick Links:
- Power Converter (Optional)
Hide quick links:
Advertisement
Table of Contents
