Scsi-Flow Flow-Id - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual
Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Configuration manual (700 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
scsi-flow flow-id
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
scsi-flow flow-id
To configure SCSI flow services, use the scsi-flow flow-id command. To disable the SCSI flow services,
use the no form of the command.
Syntax Description
flow-id
initiator-vsan vsan-id
initiator-pwwn wwn
target-vsan vsan-id
target-pwwn wwn
write-acceleration
statistics
buffers count
Defaults
SCSI flow services are disabled.
Command Modes
Configuration mode.
Command History
Release
2.0(2)
Usage Guidelines
You must enable the SCSI flow feature on the Storage Services Module (SSM) before you can configure
a SCSI flow. Use the ssm enable feature module slot-number command to enable the SCSI flow feature
on the SSM.
Examples
The following example configures a SCSI flow with a flow identifier of 4 and the following attributes:
•
•
•
•
switch# config terminal
switch(config)# scsi-flow flow-id 4 initiator-vsan 101 initiator-pwwn
21:00:00:e0:8b:05:76:28 target-vsan 101 target-pwwn 21:00:00:20:37:38:67:cf
Cisco MDS 9000 Family Command Reference
21-12
scsi-flow flow-id flow-id {initiator-vsan vsan-id initiator-pwwn wwn target-vsan vsan-id
target-pwwn wwn | statistics | write-acceleration [buffers count]}
no scsi-flow flow-id flow-id {statistics | write-acceleration]
Configures the SCSI flow identification number. The range is 1 to 65535.
Specifies the initiator VSAN identification number. The range is 1 to 4093.
Configures initiator side PWWN.
Configures target VSAN identification number of the SCSI flow.
Configures the target side PWWN.
Enables write acceleration.
Enables statistics gathering.
Configures the write acceleration buffer count. The range is 1 to 40000 and
the default is 1024.
Modification
This command was introduced.
Initiator VSAN number—101
Initiator port WWN—21:00:00:e0:8b:05:76:28
Target VSAN number—101
Target port—WWN 21:00:00:20:37:38:67:cf
Chapter 21
S Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x
Advertisement
Table of Contents
