Debug Ipacl - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual
Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Configuration manual (700 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
debug ipacl
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
debug ipacl
To enable IP access control list (ACL) debugging, use the debug ipacl command in EXEC mode. To
disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
Syntax Description
all
error
event
trace
Defaults
Disabled.
Command Modes
EXEC mode.
Command History
Release
1.0(2)
Usage Guidelines
None.
Examples
The following example displays the system output when the debug ipacl all command is issued:
switch# debug ipacl all
Related Commands
Command
no debug all
show ip access-list
Cisco MDS 9000 Family Command Reference
6-62
debug ipacl {all | error | event | trace}
no debug ipacl {all | error | event | trace}
Modification
This command was introduced.
Description
Disables all debugging.
Displays the IP access control lists that are currently active.
Enables debugging for all IP ACL features.
Enables debugging for IP ACL error conditions.
Enables debugging for the IP ACL events.
Enables debugging for IP ACL trace.
Chapter 6
Debug Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x
Advertisement
Table of Contents
