Related Manuals for Toro 22456
Summary of Contents for Toro 22456
- Page 1 Form No. 3396-376 Rev A Snowthrower Compact Utility Loader Model No. 22456—Serial No. 315000001 and Up *3396-376* A Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
Introduction 3 Installing the Cable Guide ........8 4 Installing the Snowthrower........8 Product Overview ............10 This snowthrower is intended to be used on a Toro compact Specifications ............10 utility loader. It is designed primarily for removing snow from Attachments/Accessories........10 paved surfaces, such as driveways and sidewalks, and other Operation ..............11... -
Page 3: Safety
Safety WARNING If you do not fully seat the attachment locking Improper use or maintenance by the operator or owner pins in the attachment mount plate holes, the can result in injury. To reduce the potential for injury, attachment could fall off of the traction unit severely comply with these safety instructions and those in the injuring the operator or bystanders. -
Page 4: Toro Snowthrower Safety
If the unit should start to vibrate abnormally, stop the engine and check immediately for the cause. Vibration is The following list contains safety information specific to Toro generally a warning of trouble. products or other safety information that you must know that •... -
Page 5: Stability Ratings
• To ensure the best performance and safety, purchase only genuine Toro replacement parts and accessories to keep the Toro all Toro. Do not use “Will Fit” replacement parts and accessories as they could cause a safety hazard. • When using the snowthrower in a raised position, stay away from overhead power lines and drive the traction unit only on level surfaces. -
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 63–3510 1. Discharge chute rotation 93-7310 1. Cutting/dismemberment hazard, auger—keep bystanders away from the machine. -
Page 7: Setup
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Snowthrower housing Discharge-chute assembly Deflector shield Install the discharge chute. Carriage bolt Washer Locknut Install the cable guide (200/300 series Cable guide traction units only). -
Page 8: Installing The Discharge Chute
Installing the Discharge Chute Installing the Cable Guide 200/300 Series Traction Units Parts needed for this procedure: Snowthrower housing Parts needed for this procedure: Discharge-chute assembly Cable guide Deflector shield Carriage bolt Procedure Washer Locknut 1. If your traction unit has a bolt installed in the underside of the loader-arm cross bar, between the right loader arm and the hydraulic hoses, remove the bolt. - Page 9 B. Mark the hole location on the side plate at the center of the cross hairs on the template. C. Drill a 1.00 to 1.25 cm (3/8 to 1/2 inch) hole through the frame at the marked location. Installing the Snowthrower 3.
-
Page 10: Product Overview
A selection of Toro approved attachments and accessories is available for use with the machine to enhance and expand its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a list of all approved attachments and accessories. G011833 Figure 6 1. -
Page 11: Operation
Operating Tips Operation • Always use full throttle (maximum engine speed). DANGER • If your traction unit has a speed selector, use the slow position (turtle). When the snowthrower is in operation, the impeller • If your traction unit has a flow divider, set it as appropriate and auger can be rotating and cut off or injure for the snow conditions (i.e., vary the setting from 10 hands and feet. -
Page 12: Maintenance
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Check/adjust the discharge chute. Every 25 hours • Check the auger gearbox oil. Every 50 hours • Check the condition of the scraper blade. Every 100 hours • Paint chipped surfaces. Before storage •... -
Page 13: Replacing The Scraper Blade
Replacing the Scraper Blade Adjusting the Skids Service Interval: Every 100 hours—Check the condition of Service Interval: Yearly or before storage the scraper blade. The distance between the scraper blade and the ground is Yearly or before storage—Check the condition of the controlled by skids on each side of the housing. -
Page 14: Storage
Storage 1. Before long term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Check the condition of the scraper blade. 3. Check the auger gear-box oil level. 4. Check and tighten all bolts, nuts, and screws. Repair or replace any damaged or worn parts. -
Page 15: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action The snowthrower does not operate. 1. A hydraulic coupler is not completely 1. Check and tighten all couplers. connected 2. A hydraulic coupler is damaged. 2. Check the couplers and replace any that are damaged. 3. - Page 16 Notes:...
- Page 17 Notes:...
- Page 18 The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
- Page 19 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
- Page 20 Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company. Australian Consumer Law: Australian customers will find details relating to the Australian Consumer Law either inside the box or at your local Toro Dealer.